If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Limp home mode...96 T&C
I recently had my trans rebuilt but even MORE recently, my "check engine"
light is always on and the trans goes in to "limp home" mode. For example, if I'm going 60 and the system is working properly, the tach is about 1800-1900. When I accelerate slowly, so the clutch doesn't release, the tach goes up slowly. When there is a problem, and I accelerate slowly, the clutch releases and the tach goes up quickly. When I slow down, it goes into that "limp" mode and speeds up the engine, like it's locked in 2 gear. But sometimes, I can drive for a hundred miles and it does not do any of the above, except for the "check engine" light being on. I know I should take it to a shop but if anyone has any ideas of a way to massage it--I'm 1000 miles from home. TIA John |
Ads |
#2
|
|||
|
|||
Limp home mode...96 T&C
By the way, it's the LXi with the 3.8 engine.
John |
#3
|
|||
|
|||
Limp home mode...96 T&C
The longer you drive it like this the more chance of permanent (and very
costly) damage. Take it to a place that is very familiar with Chrysler transmissions and have the trans computer scanned since it will record the failure code whenever it goes into limp mode. If you are lucky it will be a cheap and easily replaced sensor. Also, when posting for help, provide more info like the engine and mileage. Bob "Fieronut" > wrote in message lkaboutautos.com... >I recently had my trans rebuilt but even MORE recently, my "check engine" > light is always on and the trans goes in to "limp home" mode. For > example, if I'm going 60 and the system is working properly, the tach is > about 1800-1900. When I accelerate slowly, so the clutch doesn't release, > the tach goes up slowly. When there is a problem, and I accelerate > slowly, > the clutch releases and the tach goes up quickly. When I slow down, it > goes into that "limp" mode and speeds up the engine, like it's locked in 2 > gear. But sometimes, I can drive for a hundred miles and it does not do > any of the above, except for the "check engine" light being on. I know I > should take it to a shop but if anyone has any ideas of a way to massage > it--I'm 1000 miles from home. > > TIA > John > |
#4
|
|||
|
|||
Limp home mode...96 T&C
I hope the rebuilder didn't put the wrong transmission fluid in your
T&C. It's got to be ATF+3 or ATF+4 and nothing else. Much has been said about this, especially he http://www.allpar.com/fix/trans.html Ken Bob Shuman wrote: > The longer you drive it like this the more chance of permanent (and very > costly) damage. Take it to a place that is very familiar with Chrysler > transmissions and have the trans computer scanned since it will record the > failure code whenever it goes into limp mode. If you are lucky it will be a > cheap and easily replaced sensor. Also, when posting for help, provide more > info like the engine and mileage. > > Bob > > > "Fieronut" > wrote in message > lkaboutautos.com... >> I recently had my trans rebuilt but even MORE recently, my "check engine" >> light is always on and the trans goes in to "limp home" mode. For >> example, if I'm going 60 and the system is working properly, the tach is >> about 1800-1900. When I accelerate slowly, so the clutch doesn't release, >> the tach goes up slowly. When there is a problem, and I accelerate >> slowly, >> the clutch releases and the tach goes up quickly. When I slow down, it >> goes into that "limp" mode and speeds up the engine, like it's locked in 2 >> gear. But sometimes, I can drive for a hundred miles and it does not do >> any of the above, except for the "check engine" light being on. I know I >> should take it to a shop but if anyone has any ideas of a way to massage >> it--I'm 1000 miles from home. >> >> TIA >> John >> > > |
#5
|
|||
|
|||
Limp home mode...96 T&C
There are many component failures that could put it in limp home mode. I'm
going to ignore that and focus on things you can control. There are two operating conditions that make the computer mad. These a 1. The transmissions is slipping. In this case, the transmission is not able to handle all the power the engine gives it. Because it senses input and output speeds, it knows immediately when it is slipping. This might be the case you are dealing with. I would suggest using 3rd gear instead of overdrive and see if that helps at all. You want to be very easy with the acceleration. If it's reliable in 3rd gear, that's good enough to get home. 2. The transmission delays too long without getting in a gear. If shifts take too long, or if the transmission doesn't go into gear quickly when commanded, the computer will decide to go to limp mode. The way you can control this is to let off the gas so it can shift quickly. Don't do any sudden braking, as this sometimes causes the pump to lose its prime. Also, whenever it gets into limp mode due to bad shifting, simply shut the engine off and start it back up and try again. If you can only get up to speed once in every 3 or 4 tries, that's still good enough to get home. "Fieronut" > wrote in message lkaboutautos.com... >I recently had my trans rebuilt but even MORE recently, my "check engine" > light is always on and the trans goes in to "limp home" mode. For > example, if I'm going 60 and the system is working properly, the tach is > about 1800-1900. When I accelerate slowly, so the clutch doesn't release, > the tach goes up slowly. When there is a problem, and I accelerate > slowly, > the clutch releases and the tach goes up quickly. When I slow down, it > goes into that "limp" mode and speeds up the engine, like it's locked in 2 > gear. But sometimes, I can drive for a hundred miles and it does not do > any of the above, except for the "check engine" light being on. I know I > should take it to a shop but if anyone has any ideas of a way to massage > it--I'm 1000 miles from home. > > TIA > John > |
#6
|
|||
|
|||
Limp home mode...96 T&C
I took the van to a trans shop. Fortunately, the warrantee was honored
there. They found that the speed sensor was bad. Evidently, the other place had not replaced it. Now it shifts smoothly and on time and does not slip at all in any gear or clutch. Thanx to all the guys on the NG for the help. John |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
HAH 3 cylinder mode a scam? | Kevin McMurtrie | Honda | 3 | December 9th 06 11:44 PM |
96 T&C in "limp home" mode. Does it need a lot or a little? | Fieronut | Chrysler | 5 | October 19th 06 03:28 PM |
1991 Accord auto transmission - shifts in/out of 'sport' mode by itself | johnemac | Honda | 11 | November 24th 04 12:37 AM |
Best Home Base Work | Reynard | Chrysler | 0 | November 10th 04 12:51 AM |