|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#1
January 3rd 06, 01:41 PM
posted to rec.autos.makers.chrysler
|
|||
|
|||
Engine stalls with air compressor on
2002 Stratus R/T 3.0. Auto tranny
Engine stalls with air compressor on. Engine idle drops, does not increase with compressor on. Which switch controls the increased idle function? >G< 
|
| Ads |
|
#2
January 3rd 06, 04:58 PM
posted to rec.autos.makers.chrysler
|
|||
|
|||
|
Engine stalls with air compressor on
On Tue, 3 Jan 2006, Gordon wrote:
> 2002 Stratus R/T 3.0. Auto tranny > > Engine stalls with air compressor on. Engine idle drops, does not > increase with compressor on. Which switch controls the increased idle > function? That'll probably be a problem with the AIS motor (Automatic Idle Speed, known industrywide as IAC, Idle Air Control) or its circuitry.
|
|
#3
January 3rd 06, 05:45 PM
posted to rec.autos.makers.chrysler
|
|||
|
|||
|
Engine stalls with air compressor on
"Daniel J. Stern" > wrote in message n.umich.edu... > On Tue, 3 Jan 2006, Gordon wrote: > > > 2002 Stratus R/T 3.0. Auto tranny > > > > Engine stalls with air compressor on. Engine idle drops, does not > > increase with compressor on. Which switch controls the increased idle > > function? > > That'll probably be a problem with the AIS motor (Automatic Idle Speed, > known industrywide as IAC, Idle Air Control) or its circuitry. Thanks, Do you happen to know where this is located on my engine? >G<
|
|
#4
January 8th 06, 02:55 PM
posted to rec.autos.makers.chrysler
|
|||
|
|||
|
Engine stalls with air compressor on
there is a sensor on the ac line that see s a pressure increase and sends a
siganl to the pcm to step up idle using the iac and it works the same for power steering u need to check for fault codes and those codes may be in the bcm and not the pcm Gordon wrote: > "Daniel J. Stern" > wrote in message > n.umich.edu... > > On Tue, 3 Jan 2006, Gordon wrote: > > > > > 2002 Stratus R/T 3.0. Auto tranny > > > > > > Engine stalls with air compressor on. Engine idle drops, does not > > > increase with compressor on. Which switch controls the increased idle > > > function? > > > > That'll probably be a problem with the AIS motor (Automatic Idle Speed, > > known industrywide as IAC, Idle Air Control) or its circuitry. > > Thanks, Do you happen to know where this is located on my engine? > > >G<
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| rec.autos.makers.chrysler FAQ, Part 1/6 | Dr. David Zatz | Chrysler | 5 | June 24th 05 05:27 AM |
| rec.autos.makers.chrysler FAQ, Part 1/6 | Dr. David Zatz | Chrysler | 5 | June 8th 05 05:28 AM |
| rec.autos.makers.chrysler FAQ, Part 1/6 | Dr. David Zatz | Chrysler | 5 | May 24th 05 05:27 AM |
| rec.autos.makers.chrysler FAQ, Part 1/6 | Dr. David Zatz | Chrysler | 3 | February 18th 05 05:34 AM |
| rec.autos.makers.chrysler FAQ, Part 1/6 | Dr. David Zatz | Chrysler | 4 | February 2nd 05 05:22 AM |
Linear Mode
