If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
'94 Cabriolet (90) ignition switch woes...
Cabrio's ignition has started getting stiffer to turn key.... doesn't want
to spring back to the "Run" position from the "Start" position. Settles somewhat with a *little* spray of WD-40 ... Anyone have any luck with a fix shy of replacing the lock cylinder? Thanks from Nova Scotia, Kevin |
Ads |
#2
|
|||
|
|||
Hey Kevin,
It's most likley the plastic electric switch portion which mounts behind the ignition lock cylinder housing. They very often crack around the outside of the plastic switch housing causing the ignition switch to bind which in turn causes the key and lock cylinder to get stuck. I think the electrical portion (ignition switch) can be replaced without removing the lock cylinder or steering lock assm. Some models can be done by working up from under the dash once the underdash trim panel has been removed. Some require removal of the instrument cluster to gain access to rear portion of ignition lock. Good Luck, Peter |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
HELP PLEASE!!! 87 Jetta ignition switch | cjsharp | VW water cooled | 1 | July 6th 05 04:08 PM |
TIP: Ignition switch replacement (smoking) | Anastasio | Honda | 11 | July 4th 05 03:40 AM |
Ignition Switch | [email protected] | VW air cooled | 3 | March 5th 05 08:26 PM |
Ion intermittent ignition switch problem | ELY | Saturn | 3 | August 14th 04 03:18 AM |
Switch to activate upon ignition? | Michael Gaskins | General | 2 | June 1st 04 07:12 PM |