If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Jeep Cherokee ('93) Emergency Brake Lever
This evening the release button and the spring underneath it popped off
the end of the emergency brake lever. Problem is, it popped off as I was setting the brake. Now, I don't have a way to release the brake! The brake is set and I am more-or-less stuck. Fortunately, it happened at the top of the driveway. My question: is there a way to release the emergency brake without using the brake lever? As I look into the space where the button should be located, I see a metal rod, but it is flush inside the housing where the button used to be located. I did try pressing the rod with the tip of a screwdriver, but it does not move. Any suggestions would be most appreciated. |
Ads |
#2
|
|||
|
|||
Jeep Cherokee ('93) Emergency Brake Lever
On 20 Apr 2006 18:45:28 -0700, "flydog" >
wrote: >This evening the release button and the spring underneath it popped off >the end of the emergency brake lever. Problem is, it popped off as I >was setting the brake. Now, I don't have a way to release the brake! > >The brake is set and I am more-or-less stuck. Fortunately, it happened >at the top of the driveway. My question: is there a way to release the >emergency brake without using the brake lever? As I look into the space >where the button should be located, I see a metal rod, but it is flush >inside the housing where the button used to be located. I did try >pressing the rod with the tip of a screwdriver, but it does not move. > >Any suggestions would be most appreciated. Uh, tried a long screwdriver? That's my first guess. If not perhaps disconnect the cable(s)? |
#3
|
|||
|
|||
Jeep Cherokee ('93) Emergency Brake Lever
Been there. Tried but the rod would not budge. I was able to relieve
the tension on the brake cables by backing off a nut associated with the coupling under the car. It took a bit of time but at least now the car is drivable. Interestingly, the rod is still unmovable. Next challenge is to replace the lever. |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
1997 Jeep Cherokee hesitates after warmed up...... | [email protected] | Chrysler | 1 | September 22nd 05 12:48 PM |
Jeep Cherokee Coolant Leak | Ankors | Chrysler | 1 | January 23rd 05 07:01 PM |
Rear Brake Shoes - '93 Jeep Cherokee | Ralf | Jeep | 3 | January 4th 05 02:54 AM |
Jeep VS others | Elliot Westcott | Chrysler | 64 | December 19th 04 03:22 PM |