|If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below.|
||Thread Tools||Display Modes|
Remove exhaust donut gasket residue?
I'm trying to replace the donut gasket on our 2008 Pontiac Vibe
(rebadged Toyota Matrix) -- the donut at the connection between the pipe
connected to the resonator and the pipe connected to the muffler.
I've scraped and chipped away a lot of black and grey stuff, but there
are still lumps in places, and in other places something with a regular
cross-hatched appearance that looks as though it might have been the
outermost layer of the original donut.
Do I have to get down to bare shiny metal? If so, is there an an
alternative to just chipping away and wire-brushing or using a
small-enough drum sander?
The muffler and pipe are off the vehicle, so I could even use a propane
torch if it would help.
|Thread||Thread Starter||Forum||Replies||Last Post|
|On a convertibie, how to remove the front rubber gasket?||mm||Chrysler||0||July 12th 09 05:54 AM|
|93' Del Sol To Remove Oil Pan, Does Exhaust pipe need to come out /down ?||ndccpf1||Honda||0||May 19th 08 02:23 AM|
|How to remove old oil pan gasket?||[email protected]||Technology||14||January 27th 06 08:15 AM|
|How to remove old oil pan gasket?||[email protected]||VW water cooled||14||January 27th 06 08:15 AM|
|Quickest way to remove glue residue from window tint?||Crunchy Cookie||Honda||10||November 23rd 04 07:42 AM|