If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Auto transmisson problem
69 semi auto tranny is makeing a heavy tapping sound, like a very
loose rocker. It runs good but sounds bad and seems to be worse when in reverse. Any help would be appreciated Mario Vintage Werks resto |
Ads |
#2
|
|||
|
|||
Auto transmisson problem
Cracked, broken or loose drive plate maybe?
> wrote in message oups.com... > 69 semi auto tranny is makeing a heavy tapping sound, like a very > loose rocker. > It runs good but sounds bad and seems to be worse when in reverse. > > Any help would be appreciated > > Mario > Vintage Werks resto > |
#3
|
|||
|
|||
Auto transmisson problem
Not enough bondo?
> wrote in message oups.com... > 69 semi auto tranny is makeing a heavy tapping sound, like a very > loose rocker. > It runs good but sounds bad and seems to be worse when in reverse. > > Any help would be appreciated > > Mario > Vintage Werks resto > |
#4
|
|||
|
|||
Auto transmisson problem
In article >,
"dave AKA vwdoc1" > wrote: > Cracked, broken or loose drive plate maybe? > > > wrote in message > oups.com... > > 69 semi auto tranny is makeing a heavy tapping sound, like a very > > loose rocker. > > It runs good but sounds bad and seems to be worse when in reverse. > > > > Any help would be appreciated > > > > Mario > > Vintage Werks resto > > CV joints? -- If you believe that the only tool you have is a hammer, No wonder you look at all your problems as Nails. |
#5
|
|||
|
|||
Auto transmisson problem
On Apr 21, 10:12�pm, r truth > wrote:
> In article >, > *"dave AKA vwdoc1" > wrote: > > > Cracked, broken or loose drive plate maybe? > > > > wrote in message > roups.com... > > > 69 semi auto tranny is makeing a heavy tapping sound, like a very > > > loose rocker. > > > It runs good but sounds bad and seems to be worse when in reverse. > > > > Any help would be appreciated > > > > Mario > > > Vintage Werks resto > > CV joints? > > -- > If you believe that the only tool you have is a hammer, > No wonder you look at all your problems as Nails. no its comming from the center plate area and is noisey when the car isn't moveing. It does run good, so the noise is the only problem at this time. Mario Vintage Werks resto |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
$2,500 to replace the transmisson sensor chip??!! | pyramid36 | Audi | 1 | March 14th 07 08:37 AM |
How long to REBUILD a TRANSMISSON? | [email protected] | Technology | 13 | April 17th 06 05:53 PM |
Where is best place to buy a rebuilt ax15 transmisson? | [email protected] | Jeep | 5 | March 28th 05 11:21 PM |
93 Caravan Transmisson goes to Limp mode | LateNight | Dodge | 18 | October 1st 04 05:51 PM |
93 Caravan Transmisson drops out - electrical | saabturbo | Dodge | 30 | September 28th 04 02:54 PM |