If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#11
|
|||
|
|||
"Leon Rowell" > wrote in message
... > When you had the speedo cable out did you pull the cable out of the housing to see > if it might be broken? It could be broken and the two ends could intermittently Yes, I pulled it back and forth from either end... looked fine. I've got a new cable on the way so I'll just have to wait and find out. thanks Charles |
Ads |
#12
|
|||
|
|||
"v8z" > wrote in message
. .. > I believe that from '59 on, the GM speedo housing is just a cylindrical plug > with o-ring seals around its diameter and a groove in the ouside that the > hold -down sits against. Somebody correct me if I'm wrong. Yes, that's what it looks like to me... > Loosen one, easily-accessible bolt, remove the hold-down, and pull the > housing out. The driven gear just slips into it from the backside.... Thanks for the info. Since I'm rather inexperienced in the tranny department, I'm not too keen on messing with a freshly rebuilt transmission. I'll try the new cable first and then go from there. Worst case I will bring it back to the shop that rebuilt it and complain. They should have checked this the first time around since I specifically requested it. regards Charles |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Speedometer Cable | MichaelMck | Antique cars | 5 | August 5th 03 07:53 PM |