If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Cylinder head bolt order + size?
Hey group,
What's the correct order to loosen cylinder head (not cam cover) bolts? Are the bolts 12mm? Steven - - - |
Ads |
#2
|
|||
|
|||
Cylinder head bolt order + size?
Steven Spits wrote:
> Hey group, > > What's the correct order to loosen cylinder head (not cam cover) > bolts? > > Are the bolts 12mm? > According to the Enthusiast's Manual, there are 10 12mm bolts. Quoting from the manual: "Caution! The bolts must be loosened in a sequence which spirals inward from the outer bolts of the head - this minimizes distortion. Initially loosen each bolt half a turn, then a whole turn, followed by full removal. A 125mm/5inch extension will be needed with the socket as the bolts are quite deeply recessed in the cambox." The workshop manual has a diagram showing removal of the bolts in the following order: 3 7 10 6 2 4 8 9 5 1 Hope that helps. Iva & Belle.) '90B Classic Red.) #3 winkin' Miata |
#3
|
|||
|
|||
Cylinder head bolt order + size?
Iva wrote:
> The workshop manual has a diagram showing removal of the bolts in the > following order: Perfect, thanks!!! Steven - - - |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
1996 SL2 Valve Cover bolt order | [email protected] | Saturn | 1 | December 29th 06 10:23 PM |
2001 Honda CR-V TSB for cylinder not firing -- replace cylinder head | NewtA4RX330 | Honda | 2 | November 23rd 06 04:51 PM |
bolt size? | John Gindlesberger | Mazda | 4 | October 3rd 05 07:56 PM |
Bolt size? | 83 CJ | Jeep | 1 | September 19th 05 07:58 PM |
Cylinder head Bolt Torque | Brian | Chrysler | 3 | August 30th 05 11:52 PM |