If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
I found the right FFB settings
Mario Petrinovic:
Mario Petrinovic: Spring, Damper and Centering Spring have to be at the same value. Not any value, but at the value where slack is eliminated. At my system this happens at 82. So, my settings are 118/82/82/82. Now I relized why it was so difficult to find it. It is easy to find it on Star Mazda, with the stock baseline setup, but this week's fixed Dallara is terrible (probably Dallara in general is terrible). Also, this week's fixed Silverado is extremly bad. With it I would never found it. Probably a lot of other cars and setups are also very bad. -------------------------------------------------------------------------------- Ah, wrong again, : ). -------------------------------------------------------------------------------- Ok, I found it. Ha, ha, bravo me. The FFB puzzle is solved, thanks god. First I must say something about iRacing's FFB. It was unlinear. Which reminds of a guy who blamed me tham MY wheel is unlinear. Well guy, guess what, your is unlinear too, only YOU don't see it. Get it? Also, this reminds me on a discussion from iRacing's forum, way back, when people laughed when I mentioned N4S FFB as better than that of N2003. Well, gueas what, while "the most realistic" simulation on Earth had unlinear FFB, probably any other simulation (which wasn't "the most realistic") had LINEAR FFB. Lol, I always claimed that Papyrus/iRacing doesn't undertsand FFB. Now, that finely, AFTER 15 YEARS, they decided to put LINEAR FFB in "the most realistic" simulation of all times, it was EASY to determine "the right" FFB, *beacause* FFB was FINALY *ballanced*. For god's sake, people, what a JOKE. "THE right" settings are, in Logitech driver, ---/100/100/100, I have "Allow game to adjust settings" unchecked, Centering Spring also unchecked. In-game it should be 20/50 (both sliders at the half-way point). Regarding Overall, right now I have it at 125%, but I didn't test other options. At 125% is just a little bit too heavy for me, probably it should be somewhere around 120% for me. 100% definitely is too low. Regarding "cockpitLookDeadZone", I have it at iRacing's default 0.05, right now. I didn't have time to test other values, but from my experience, probably it should be at the iRacing's default. |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
New PC's FFB | Mario Petrinovic | Simulators | 40 | May 27th 12 10:45 PM |
How to balance FFB | Mario Petrinovic | Simulators | 30 | January 28th 12 08:16 AM |
FFB (so far) | Mario Petrinovic | Simulators | 0 | September 25th 11 10:57 AM |
FFB | Mario Petrinovic | Simulators | 26 | September 5th 11 08:52 AM |
G25 v. ECCI - To FFB or not to FFB | [email protected] | Simulators | 1 | August 17th 07 02:35 PM |