If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
How do you install a heater control valve on a 1990 Plymouth Acclaim 2.5?
I am trying to find out how to replace a heater control valve on my car. I
am not sure how to know what hose goes where, can someone please help me? If so please provide as much detail as possible I am a "Rookie" |
Ads |
#2
|
|||
|
|||
How do you install a heater control valve on a 1990 Plymouth Acclaim 2.5?
"PhillyGirl26" > wrote in message lkaboutautos.com... > I am trying to find out how to replace a heater control valve on my car. I > am not sure how to know what hose goes where, can someone please help me? > If so please provide as much detail as possible I am a "Rookie" > ummm, before you take it off write down where the hoses go to each one, or take one off the old one put it back on the new one till its done, or take a picture wiith a digital camera and print out, Acually its cut and dry how it is installed Glenn Beasley Chrysler Tech |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
rec.autos.makers.chrysler FAQ, Part 1/6 | Dr. David Zatz | Chrysler | 5 | September 11th 05 05:25 AM |
rec.autos.makers.chrysler FAQ, Part 1/6 | Dr. David Zatz | Chrysler | 5 | August 26th 05 05:30 AM |
rec.autos.makers.chrysler FAQ, Part 1/6 | Dr. David Zatz | Chrysler | 5 | July 10th 05 05:24 AM |
rec.autos.makers.chrysler FAQ, Part 1/6 | Dr. David Zatz | Chrysler | 5 | June 24th 05 05:27 AM |
1990 325i, worn valve stem.. | [email protected] | BMW | 0 | February 6th 05 01:37 AM |