|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#1
September 9th 05, 04:40 AM
|
|||
|
|||
Broken Temp probe for fan relay
The temp probe for my fan relay broke. It was so corroded that it
broke in half. Is it possible to buy a new temp probe and splice it in? What about the probe wires to the temp sending unit? Or should I just buy a new kit? I have connected the the wire for the a/c switch to constant hot as a temporary solution. 
|
| Ads |
|
#2
September 9th 05, 07:37 PM
|
|||
|
|||
|
Evan wrote:
> The temp probe for my fan relay broke. It was so corroded that it > broke in half. Is it possible to buy a new temp probe and splice it in? > What about the probe wires to the temp sending unit? Or should I just > buy a new kit? > > I have connected the the wire for the a/c switch to constant hot as a > temporary solution. > It's a Borden tube, and can't be repaired. -- ..boB 1997 HD FXDWG - Turbocharged! 2001 Dodge Dakota QC 5.9/4x4/3.92 1966 Mustang Coupe - Daily Driver 1965 FFR Cobra - Finally on the Road!
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| evaporator temp probe | [email protected] | Chrysler | 24 | July 3rd 05 03:42 PM |
| Auxilliary power distribution box | Simon H | Ford Explorer | 7 | April 3rd 05 01:48 AM |
| Updated Main Relay theory - Feb14/05 | [email protected] | Honda | 0 | February 17th 05 08:05 AM |
| 1996 Dodge Grand Caravan LE AC/Heater Blower, Relay and Resistor Block Problems 101 | HeadlessHorseman | Dodge | 0 | January 5th 05 02:49 PM |
Linear Mode
