If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Thermostat Question
My 96 chevy truck was running cool according to the temp gauge so when
I replaced the water pump, I flushed out the cooling system and put in a new 195 degree thermostat along with Dex-Cool antifreeze. Now it runs even cooler! It is my understanding that the engine runs more effeciently at the design temp, 195. If this is true, how in the heck do I get it to run hotter? It used to run hotter when new... Maybe the gauge is lying to me? Maybe the thermostat (a Thompson from NAPA) is no good? Would you guys please advise me on what to do? thanks, Libby |
Ads |
#2
|
|||
|
|||
Thermostat Question
Libby Chantel > wrote:
>My 96 chevy truck was running cool according to the temp gauge so when >I replaced the water pump, I flushed out the cooling system and put in >a new 195 degree thermostat along with Dex-Cool antifreeze. Now it runs >even cooler! It is my understanding that the engine runs more >effeciently at the design temp, 195. If this is true, how in the heck >do I get it to run hotter? It used to run hotter when new... Maybe the >gauge is lying to me? Maybe the thermostat (a Thompson from NAPA) is no >good? > >Would you guys please advise me on what to do? The thermostat is the only thing that can cause the problem (other than a bad temperature gauge or sensor). A bad water pump or bad coolant will cause it to run hot because it's not cooling _enough_. Your problem is that it is cooling _too much_. Do the thermostat. It is a _lot_ easier than swapping the water pump. --scott -- "C'est un Nagra. C'est suisse, et tres, tres precis." |
#3
|
|||
|
|||
Thermostat Question
How are you determining your engine's temperature? I doubt the dash
gauge is particularly accurate - especially on a 10 year old truck. Ed |
#4
|
|||
|
|||
Thermostat Question
: )
I had already replaced the water pump because the bearing failed. At the same time I replaced the thermostat and the coolant. Now it runs at about 160 with a new 195 thermostat, which is the problem I am currently trying to solve. Thanks, Libby "una mas cervaza, por favor, señorita." |
#5
|
|||
|
|||
Thermostat Question
On 17 Nov 2005 07:59:08 -0800, > wrote:
>: ) > I had already replaced the water pump because the bearing failed. At > the same time I replaced the thermostat and the coolant. Now it runs at > about 160 with a new 195 thermostat, which is the problem I am > currently trying to solve. If you've got a 195 thermostat in and it never runs above 160, then either your temp gauge is off or the thermostat is bad. I don't believe your engine would be able to stay at 160 with the thermostat closed. John. |
#6
|
|||
|
|||
Thermostat Question
Temperature gauges are notoriously inaccurate. Most thermostats open at the correct temperature, but some do not. About a year ago I replaced an old thermostat that opened at about 185 degF with a new one that opened at about 205 degF. Both were rated for 195 degF. The rated temperature is the temperature at which the thermostat is supposed to start opening. If you put a 195 degF thermostat in a pan of water and heat it, it should start to open at 195 deg and be fully opened at about 210 deg. When my new thermostat was only half open with the water boiling I new it was out of specs. Libby Chantel wrote: > > My 96 chevy truck was running cool according to the temp gauge so when > I replaced the water pump, I flushed out the cooling system and put in > a new 195 degree thermostat along with Dex-Cool antifreeze. Now it runs > even cooler! It is my understanding that the engine runs more > effeciently at the design temp, 195. If this is true, how in the heck > do I get it to run hotter? It used to run hotter when new... Maybe the > gauge is lying to me? Maybe the thermostat (a Thompson from NAPA) is no > good? > > Would you guys please advise me on what to do? > > thanks, > Libby -- Mike Walsh West Palm Beach, Florida, U.S.A. |
#7
|
|||
|
|||
Thermostat Question
How is the interior heat level?
If it is the same or not noticeably different, then I would suspect the connection on the sender or just a crappie sender. Mike 86/00 CJ7 Laredo, 33x9.5 BFG Muds, 'glass nose to tail in '00 88 Cherokee 235 BFG AT's Canadian Off Road Trips Photos: Non members can still view! Aug./05 http://www.imagestation.com/album/in...?id=2120343242 (More Off Road album links at bottom of the view page) Libby Chantel wrote: > > My 96 chevy truck was running cool according to the temp gauge so when > I replaced the water pump, I flushed out the cooling system and put in > a new 195 degree thermostat along with Dex-Cool antifreeze. Now it runs > even cooler! It is my understanding that the engine runs more > effeciently at the design temp, 195. If this is true, how in the heck > do I get it to run hotter? It used to run hotter when new... Maybe the > gauge is lying to me? Maybe the thermostat (a Thompson from NAPA) is no > good? > > Would you guys please advise me on what to do? > > thanks, > Libby |
#8
|
|||
|
|||
Thermostat Question
Interior heat is not noticeably different. Heater is not as hot as it
used to be when truck was new. Would this work: get it to operating temp then stick a cookie thermometer into the water and read the temp accurately, in order to verify thermostat? If it is really 160 it shouldn't spew out when I open the cap, right? If it does I can put the thermometer into the overflow cannister and check it that way. Thanks, Libby |
#9
|
|||
|
|||
Thermostat Question
"Libby Chantel" > wrote in
ups.com: > Interior heat is not noticeably different. Heater is not as hot as it > used to be when truck was new. > > Would this work: get it to operating temp then stick a cookie > thermometer into the water and read the temp accurately, in order to > verify thermostat? If it is really 160 it shouldn't spew out when I > open the cap, right? If it does I can put the thermometer into the > overflow cannister and check it that way. > > Thanks, > Libby > > none of that is a good idea, best is to use a aftermarket gauge to check the temp. second is use a touchless remote sensor (infrared thermoter) the block and tstat housing, it has worked pretty good for me. and you can check the rad and rest of the system for poor performance. KB -- ThunderSnake #9 Warn once, shoot twice 460 in the pkup, 460 on the stand for another pkup and one in the shed for a fun project to yet be decided on |
#10
|
|||
|
|||
Thermostat Question
"Libby Chantel" > wrote in message oups.com... > My 96 chevy truck was running cool according to the temp gauge so when > I just drove back from Houston today during a cool snap, and have noticed the same apparent lack of engine heat. I think it is really only due to a very inaccurate dash temperature gauge, since the car ran fine and got reasonable mileage. I have seen people put cardboard or other in front of the radiator to partially block the airflow. That would be an easy solution, but I wouldnt do it unless I were darn sure about the actual temperature. |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
No thermostat in 96 Subaru Outback Wagon | rajp | Technology | 4 | October 12th 05 03:48 AM |
Thermostat problem on VUE | [email protected] | Saturn | 1 | January 10th 05 03:28 AM |
Where to get Official Speed Limit Info | [email protected] | Driving | 40 | January 3rd 05 07:10 AM |
Need help to replace thermostat on 1993 325i sedan | Lyle_s | BMW | 7 | December 31st 04 10:30 AM |