If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Radiator to fan clearance
I have a 66 inline6 that I replaced the 2 core radiator with a 3 core
Transpro Ready-Rad from AutoZone. Now the fan is less than a 1/4" from the radiator. I thought I would just cut down the spacer but when I took the fan off the fan and spacer are one unit. The spacer looks like it is "riveted" to the fan. Can I just grind the "rivet" off, cut down the spacer, and bolt the fan and spacer back together or do I have to buy a new fan and spacer kit? Richard |
Ads |
#2
|
|||
|
|||
|
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Adjusting valve clearance e36 M3 s52 motor | Abs | BMW | 0 | March 7th 05 03:06 AM |
CJ? Engine Well Clearance ? | Spike | Ford Mustang | 23 | March 1st 05 02:24 AM |
intersection clearance time (both directions red) | Daniel J. Stern | Driving | 1 | February 22nd 05 01:14 AM |
Best roll bar for head clearance? | John McClary | Mazda | 9 | December 8th 04 05:03 AM |
Air Filter Deck Lid Clearance problem | Spike | VW air cooled | 6 | November 20th 04 02:45 PM |