If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Wrangler AC Setting Problem..
Does anyone have any ideas on why my 97 Wrangler AC will work on the first three settings but when I turn it all the way up it cuts off. It does this with the AC/Heat or just the fan. First three work great when it hits the highest it goes silent.. With these 95 degree days here I could really use that high setting!! Thanks for any help! P.S. I tried changing the relay behind the dash like some suggested a while back. No luck. SP |
Ads |
#2
|
|||
|
|||
it is either the resistor or the ac control board both are easy fixes.. try
the resistor 1st 15 bucks... if no help the control board is about 60 bucks both are easy to install "sp" > wrote in message ... > > Does anyone have any ideas on why my 97 Wrangler AC will work on the > first three settings but when I turn it all the way up it cuts off. > It does this with the AC/Heat or just the fan. > First three work great when it hits the highest it goes silent.. > > With these 95 degree days here I could really use that high setting!! > > > Thanks for any help! > P.S. I tried changing the relay behind the dash like some suggested a > while back. No luck. > > > SP |
#3
|
|||
|
|||
Sounds like the resistor, or the control unit.
Larry "sp" > wrote in message ... > > Does anyone have any ideas on why my 97 Wrangler AC will work on the > first three settings but when I turn it all the way up it cuts off. > It does this with the AC/Heat or just the fan. > First three work great when it hits the highest it goes silent.. > > With these 95 degree days here I could really use that high setting!! > > > Thanks for any help! > P.S. I tried changing the relay behind the dash like some suggested a > while back. No luck. > > > SP |
#4
|
|||
|
|||
Relay in your Power Distribution Center Box next to your battery:
http://www.billhughes.com/blower.pdf God Bless America, ßill O|||||||O sp wrote: > > Does anyone have any ideas on why my 97 Wrangler AC will work on the > first three settings but when I turn it all the way up it cuts off. > It does this with the AC/Heat or just the fan. > First three work great when it hits the highest it goes silent.. > > With these 95 degree days here I could really use that high setting!! > > > Thanks for any help! > P.S. I tried changing the relay behind the dash like some suggested a > while back. No luck. > > SP |
#5
|
|||
|
|||
Thanks for the answers...
I tried to swap the one labeled AC with another one of the same type in the box. But no luck. Sitll no highest setting My horn also stopped working about the same time.. Somehting funky electrical must be going on. Thanks Shawn On Fri, 01 Jul 2005 11:37:08 -0700, L.W.(ßill) Hughes III > wrote: > Relay in your Power Distribution Center Box next to your battery: >http://www.billhughes.com/blower.pdf > God Bless America, ßill O|||||||O > >sp wrote: >> >> Does anyone have any ideas on why my 97 Wrangler AC will work on the >> first three settings but when I turn it all the way up it cuts off. >> It does this with the AC/Heat or just the fan. >> First three work great when it hits the highest it goes silent.. >> >> With these 95 degree days here I could really use that high setting!! >> >> >> Thanks for any help! >> P.S. I tried changing the relay behind the dash like some suggested a >> while back. No luck. >> >> SP |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
rec.autos.makers.chrysler FAQ, Part 1/6 | Dr. David Zatz | Chrysler | 6 | December 7th 06 04:55 PM |
rec.autos.makers.chrysler FAQ, Part 4/6 | Dr. David Zatz | Chrysler | 0 | April 22nd 05 05:32 AM |
rec.autos.makers.chrysler FAQ, Part 1/6 | Dr. David Zatz | Chrysler | 5 | March 21st 05 05:33 AM |
rec.autos.makers.chrysler FAQ, Part 1/6 | Dr. David Zatz | Chrysler | 7 | February 1st 05 01:43 PM |
New *FREE* Corvette Discussion Forum | JLA ENTERPRISES TECHNOLOGIES INTEGRATION | Corvette | 12 | November 30th 04 06:36 PM |