If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
No power, rough idle
98 SL1, 165,000km
I have rough idle down around 500-750RPM (it usually idles just over 1000RPM). Very little power. When I floor it in neutral the RPM gauge goes to 4200 and pulses. Looking under the hood at lunch time and the PCV hose was cracked/split and flattened. I replaced the hose but that seemed to make it worse. I remember talk on here of cleaning the PCV vavle but the Haynes manual I have only says what it does, no mention of cleaning. My question is, what should I clean it with? compressed air, gasoline, methyl hydrate...? Or should I just get a new one? Does this sound like a dirty or defective PCV valve or should I continue to look for other causes? Any advice or suggestion will be greatly appreciated. Roy |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
rec.autos.makers.chrysler FAQ, Part 1/6 | Dr. David Zatz | Chrysler | 5 | June 8th 05 05:28 AM |
rec.autos.makers.chrysler FAQ, Part 1/6 | Dr. David Zatz | Chrysler | 5 | May 24th 05 05:27 AM |
rec.autos.makers.chrysler FAQ, Part 1/6 | Dr. David Zatz | Chrysler | 3 | February 18th 05 05:34 AM |
rec.autos.makers.chrysler FAQ, Part 1/6 | Dr. David Zatz | Chrysler | 4 | February 2nd 05 05:22 AM |
rec.autos.makers.chrysler FAQ, Part 1/6 | Dr. David Zatz | Chrysler | 10 | November 16th 04 05:28 AM |