If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
'89 fuel injectors
What is the standard amount of time allotted for
a shop to remove and install a set of injectors? thanks, JC |
Ads |
#2
|
|||
|
|||
I think some of the specialists around here use a formula:
Number of hours X hourly rate = daily limit on debit card Adjust the first two elements to fit the third. Charlie "J C P" <JCP1STatADAMSdotNET> wrote in message ... > What is the standard amount of time allotted for > a shop to remove and install a set of injectors? > thanks, > > JC > > |
#3
|
|||
|
|||
you are close Charlie
for the ZR-1 it is 2.0 hours for the first on and .1 hours for each additional one. for a non ZR-1 it is 4.2 hours for the first one and .1for each additional one. this includes R&I intake plenum. does not include cleaning or any broken or stripped or rusted parts. labor GUIDE times come from Mitchel, and most shops use this as just that a "GUIDE" Greg On Thu, 14 Jul 2005 09:14:41 -0500, "Charlie Funk" > wrote: >I think some of the specialists around here use a formula: > >Number of hours X hourly rate = daily limit on debit card > >Adjust the first two elements to fit the third. > >Charlie > >"J C P" <JCP1STatADAMSdotNET> wrote in message ... >> What is the standard amount of time allotted for >> a shop to remove and install a set of injectors? >> thanks, >> >> JC >> >> > |
#4
|
|||
|
|||
Yep - that's the formula my local dealership has been
using !! "Charlie Funk" > wrote in message ... > I think some of the specialists around here use a formula: > > Number of hours X hourly rate = daily limit on debit card > > Adjust the first two elements to fit the third. > > Charlie > > "J C P" <JCP1STatADAMSdotNET> wrote in message > ... > > What is the standard amount of time allotted for > > a shop to remove and install a set of injectors? > > thanks, > > > > JC > > > > > > |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Fastback fuel injectors, cleaning, rebuilding? | CROQ | VW air cooled | 5 | July 10th 05 11:09 PM |
warman i am surprised you mix oil | [email protected] | Ford Mustang | 5 | May 8th 05 04:04 AM |
DaimlerChrysler Commits Over $70 Million to Fuel Cell | Shrike | Dodge | 0 | March 30th 05 09:03 PM |
Failed Smog Check 1981 Trans AM | TheSmogTech | Technology | 0 | January 30th 05 04:16 PM |
1989 Chevrolet Celebrity Fuel Injectors | Larry R Harrison Jr | Technology | 1 | January 24th 05 08:43 AM |