|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#1
March 22nd 05, 09:44 AM
|
|||
|
|||
Can i put 1300 heads (twinport) on a 1600 engoen block & barrels/pistons ?
Or do i need to modify more then just the cylinder hole size?
Bart Bervoets 
|
| Ads |
|
#2
March 22nd 05, 11:24 AM
|
|||
|
|||
|
"Bart Bervoets" > wrote: >Or do i need to modify more then just the cylinder hole size? > >Bart Bervoets > > I don't think so... I made the same to my engine 1 month ago. It was a AB 1300DP and now it is a A? 1600 DP. I also replaced the carb to a 34 Pict3 and the manifold. The valves are the same for the 1300DP and 1600DP Joao 72 Super 1302
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| 1300 to 1600 | Joao Eliseu | VW air cooled | 4 | February 26th 05 04:27 PM |
| 044 heads vs stock heads on stock size piston/barrels | Matt S | VW air cooled | 1 | February 25th 05 04:04 AM |
| 1300 to 1600 | Joao Eliseu | VW air cooled | 8 | January 8th 05 10:17 PM |
Linear Mode
