If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
|
#1
|
|||
|
|||
How do I remove door panels on 1993 e34?
I am getting ready to rehab our 1993 525 (M50 motor) and need some assistance so I can speed up the process. I will be removing the interior, rear door panels to replace the window motors and regulators. What is the best method for removing the door panels without breaking any retaining clips or such? I am posting other questions since I have one week to replace the hood, grille, front left fender, windshield washer reservoir, valve cover gasket, ashtray frame, rear window motors and regulators, driver's seat belt receiver, rear right door seal, and wheels. Thanks, ---Walt -- wmjsplace ------------------------------------------------------------------------ wmjsplace's Profile: http://www.usenetcars.com/member.php?userid=1375 View this thread: http://www.usenetcars.com/showthread.php?t=242850 |
#2
|
|||
|
|||
wmjsplace wrote:
> I will be removing the interior, rear door panels to replace the window > motors and regulators. > > What is the best method for removing the door panels without breaking > any retaining clips or such? > > I am posting other questions since I have one week to replace the hood, > grille, front left fender, windshield washer reservoir, valve cover > gasket, ashtray frame, rear window motors and regulators, driver's seat > belt receiver, rear right door seal, and wheels. > > Thanks, > > ---Walt It's actually almost impossible to remove the interior door panels without breaking some of the plastic clips - especially as the car gets older. Go to BMW before removing it and buy spares - quite a few actually. They're cheap. Then - (from memory - haven't owned an E34 in about 8 years now) - there is a plastic push in cover on the armrest. Remove cover, there is a screw behind it. Remove the screw. Remove the screw behind the little handle you open the door with, and pull this out. It isn't necessary to disconnect it, but it's also not hard to disconnect. NOTE where and how the cable attaches since you have to get it back that way. Use a flat putty knife and work around the bottom and side of the panel - pulling it out so the clips release. Once all the clips are out - grab the armrest and push the panel upwards so the window molding releases. Rinstallation is the reverse.. |
#3
|
|||
|
|||
go to ... http://www.bimmer.info/forum/forumdisplay.php?f=10
it is a e34 forum, they have all the answers! also for do it yourself repairs... http://www.bmwe34.net/ thank me later, these are the 2 best links out there! "wmjsplace" > wrote in message ... > > I am getting ready to rehab our 1993 525 (M50 motor) and need some > assistance so I can speed up the process. > > I will be removing the interior, rear door panels to replace the window > motors and regulators. > > What is the best method for removing the door panels without breaking > any retaining clips or such? > > I am posting other questions since I have one week to replace the hood, > grille, front left fender, windshield washer reservoir, valve cover > gasket, ashtray frame, rear window motors and regulators, driver's seat > belt receiver, rear right door seal, and wheels. > > Thanks, > > ---Walt > > > -- > wmjsplace > ------------------------------------------------------------------------ > wmjsplace's Profile: http://www.usenetcars.com/member.php?userid=1375 > View this thread: http://www.usenetcars.com/showthread.php?t=242850 > |
#4
|
|||
|
|||
How do I remove door panels on 1993 e34?
replying to wmjsplace, DuttoMan wrote:
I have found a link of a video showing the process of removing the rear door panels from E32 which is similar to E34s. Those who are looking to removing the front door, you will just have to pry open the power mirror switch and the rest of the process is pretty much same. Here is the link of the video. https://youtu.be/wDPKggWZIZU -- for full context, visit http://www.motorsforum.com/bmw/how-d...-e34-2643-.htm |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
FS: Working 1993 Ford Explorer Limited HAMILTON, ONTARIO | [email protected] | Ford Explorer | 0 | March 8th 05 04:11 AM |
Remove the fuel pump on a 1995 VR6 | Mark | VW water cooled | 14 | January 2nd 05 11:52 AM |
Infiniti Q45 oil pan removal procedure | Miki | Technology | 25 | December 30th 04 12:07 AM |
Ebay auction 1993 626 Mazda Factory Service Manual | Dale Alexander | General | 0 | March 14th 04 05:11 AM |