If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Error codes 12 & 21
When I do the 3 time key turn thing.. I get these 2 codes. One is power
loss (I'm paraphrasing) like when you disconnect the battery. But My clock, etc have no memory loss. The second code, 21 is for a bad O2 sensor which I change about 6 months ago. Is it bad wiring maybe? What should I check for? Posted a while ago but rec'd no response. Please help. thanks in advance for any info which can help, -- Mel 97 Cherokee |
Ads |
#2
|
|||
|
|||
I would pull the battery cable off for 15 minutes or so to reset the
codes and see what happens. Mike 86/00 CJ7 Laredo, 33x9.5 BFG Muds, 'glass nose to tail in '00 88 Cherokee 235 BFG AT's "Mel P." wrote: > > When I do the 3 time key turn thing.. I get these 2 codes. One is power > loss (I'm paraphrasing) like when you disconnect the battery. But My clock, > etc have no memory loss. The second code, 21 is for a bad O2 sensor which I > change about 6 months ago. > > Is it bad wiring maybe? What should I check for? > > Posted a while ago but rec'd no response. Please help. > > thanks in advance for any info which can help, > > -- > Mel > > 97 Cherokee |
#3
|
|||
|
|||
can this test be done on a '02 Laredo and how do you do it? "Mike Romain" > wrote in message ... >I would pull the battery cable off for 15 minutes or so to reset the > codes and see what happens. > > Mike > 86/00 CJ7 Laredo, 33x9.5 BFG Muds, 'glass nose to tail in '00 > 88 Cherokee 235 BFG AT's > > "Mel P." wrote: >> >> When I do the 3 time key turn thing.. I get these 2 codes. One is >> power >> loss (I'm paraphrasing) like when you disconnect the battery. But My >> clock, >> etc have no memory loss. The second code, 21 is for a bad O2 sensor >> which I >> change about 6 months ago. >> >> Is it bad wiring maybe? What should I check for? >> >> Posted a while ago but rec'd no response. Please help. >> >> thanks in advance for any info which can help, >> >> -- >> Mel >> >> 97 Cherokee |
#4
|
|||
|
|||
Turn the ignition key until the digital odometer displays, repeat
three times in succession and then back to "On" (On/Off, On/Off, On/Off, On). At the fourth "On" the odometer will be replaced with codes. If no codes are present then "Done" will appear. http://www.wjjeeps.com/faultcodes.htm God Bless America, ßill O|||||||O http://www.billhughes.com/ JoE' wrote: > > can this test be done on a '02 Laredo and how do you do it? |
Thread Tools | |
Display Modes | |
|
|