If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#11
|
|||
|
|||
Anyone know what this is?
On Tue, 28 Feb 2012 18:25:31 -0600, DougW wrote:
> Dale Beckett wrote: > >> Here's a better (closer) view of the same picture he sent to me. It >> seems to me there are an awful lot of wires there for an ign module. >> That radiator support couldn't be in a worse place in the picture. >> Those wires go to a plug and then disappear into a wire loom. >> >> http://img23.imageshack.us/img23/9597/img1124anp.jpg > > Take a look at this again. > http://oljeep.com/gw/elec/83/83_FSJ_...ompartment.jpg > > Probably going to have to trace the wire from the starter solinoid but > even with color differences that look like what it is. Also note in that > drawing the IGN module is _in_ the engine compartment. It isn't the ignition module, for the 1982 and earlier CJ that's a Motorcraft unit bolted to the left fender skirt, under the washer jug, with two or three round connectors. <http://tinyurl.com/89g3tbm> What he's got is the US 1982-1982 ECM for the Carter BBD stepper motor. In the next model year it was relocated to inside the cab, above the glove box. See this discussion (keyword seek "John Nutter Bypass" for the right section. That seek will put you just above a photo of an identical unit. http://www.jeepforum.com/forum/f8/tf...saster-971493/ |
Ads |
#12
|
|||
|
|||
Anyone know what this is?
Lee Ayrton said:
[snip] > What he's got is the US 1982-1982 ECM for the Carter BBD stepper motor. > In the next model year it was relocated to inside the cab, above the > glove box. See this discussion (keyword seek "John Nutter Bypass" for > the right section. That seek will put you just above a photo of an > identical unit. > > http://www.jeepforum.com/forum/f8/tf...saster-971493/ Now you're talking! Thanks a million. -- Dale Beckett |
#13
|
|||
|
|||
Anyone know what this is?
On Wed, 29 Feb 2012 23:58:21 +0000, Dale Beckett wrote:
> Lee Ayrton said: > [snip] >> What he's got is the US 1982-1982 ECM for the Carter BBD stepper motor. >> In the next model year it was relocated to inside the cab, above the >> glove box. See this discussion (keyword seek "John Nutter Bypass" for >> the right section. That seek will put you just above a photo of an >> identical unit. >> >> http://www.jeepforum.com/forum/f8/tf...saster-971493/ > > Now you're talking! > > Thanks a million. De nada. |
Thread Tools | |
Display Modes | |
|
|