A Cars forum. AutoBanter

If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below.

Go Back   Home » AutoBanter forum » Auto makers » Corvette
Site Map Home Register Authors List Search Today's Posts Mark Forums Read Web Partners

01 headlight motor



 
 
Thread Tools Display Modes
  #1  
Old January 24th 06, 11:56 AM posted to alt.autos.corvette
external usenet poster
 
Posts: n/a
Default 01 headlight motor

a few months ago the drivers side motor locked up and wouldn't go up.
I remembered my 66 had a knob that would get tight and if I loosened it the
light would work again.
So I tried it on the 01, the knob wouldn't turn so I twisted harder and it
snapped and that was it. I replaced the motor and works fine.
Now the right side locks down on me so with little faith I tried the same
thing again this time a little more easily till it freed itself, loosened
the motor and it worked fine.
Now after 4 months or so it has happened for the third time, I loosen it and
it works fine.
Q. ? Am I postponing the inevitable ?
or is there some fix to keep it from tightening ?
I haven't seen anyone post about this (fix) here

kickstart



Ads
  #2  
Old January 29th 06, 12:38 PM posted to alt.autos.corvette
external usenet poster
 
Posts: n/a
Default 01 headlight motor

In article >,
"Kickstart" > wrote:

> a few months ago the drivers side motor locked up and wouldn't go up.
> I remembered my 66 had a knob that would get tight and if I loosened it the
> light would work again.
> So I tried it on the 01, the knob wouldn't turn so I twisted harder and it
> snapped and that was it. I replaced the motor and works fine.
> Now the right side locks down on me so with little faith I tried the same
> thing again this time a little more easily till it freed itself, loosened
> the motor and it worked fine.
> Now after 4 months or so it has happened for the third time, I loosen it and
> it works fine.
> Q. ? Am I postponing the inevitable ?
> or is there some fix to keep it from tightening ?
> I haven't seen anyone post about this (fix) here
>
> kickstart


While my 01 was under warranty, the dealer replaced both side. They
gave up on trying to repair and just replaced them.
 




Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

vB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Forum Jump

Similar Threads
Thread Thread Starter Forum Replies Last Post
1996 Dodge Grand Caravan LE AC/Heater Blower, Relay and Resistor Block Problems 101 HeadlessHorseman Dodge 2 January 12th 06 11:12 PM
01 headlight motor Kickstart Corvette 3 September 15th 05 04:47 PM
1996 Dodge Grand Caravan LE AC/Heater Blower, Relay and Resistor Block Problems 101 HeadlessHorseman Dodge 0 January 5th 05 02:49 PM
Climatronic Diagnostic Controls Luís Lourenço Audi 1 November 12th 04 08:22 AM


All times are GMT +1. The time now is 02:02 PM.


Powered by vBulletin® Version 3.6.4
Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.
Copyright ©2004-2024 AutoBanter.
The comments are property of their posters.