If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
vents blow alr out the defrost and florr
I have a 1995 mustang v6 the air con works but about two weeks ago it
started to only come out the defrost and floorboard it doen't matter what the control is set on any suggestions Rick |
Ads |
#2
|
|||
|
|||
On Mon, 20 Jun 2005 11:14:43 -0500, "richard" > wrote:
>I have a 1995 mustang v6 the air con works but about two weeks ago it >started to only come out the defrost and floorboard it doen't matter what >the control is set on any suggestions >Rick > replacr the blend door LMFAO h u r c a s t |
#3
|
|||
|
|||
Check the small black hard plastic tube that runs along the back of the
firewall from the heater fittings to the vacuum "T" next to the brake booster. It is VERY common for this vacuum line to get brittle and break. Without vacuum the vents will default to the defrost position at the windshield. If broken place a piece of small vacuum hose between the break. If broken at rubber fitting on the end where it goes to the "T", drill it out and reinsert tube back into rubber and super glue. Hope this is helpful, TIM (Musttanguy) PonyPerformance.com |
#4
|
|||
|
|||
> wrote in message ... > On Mon, 20 Jun 2005 11:14:43 -0500, "richard" > wrote: > >>I have a 1995 mustang v6 the air con works but about two weeks ago it >>started to only come out the defrost and floorboard it doen't matter what >>the control is set on any suggestions >>Rick >> > > replacr the blend door > LMFAO > h > u > r > c > a > s > t > Yes! "Replacr" it immediately! |
#5
|
|||
|
|||
If I wanted to see the moron's posts I wouldn't have him blocked. It's
clear that to avoid the troll I must also filter Brian. Plonk Brian wrote: |
#6
|
|||
|
|||
|
#7
|
|||
|
|||
Yep, this happened on mine; did what Tim says and it's good as new.
John "Musttanguy" > wrote in message oups.com... > Check the small black hard plastic tube that runs along the back of the > > firewall from the heater fittings to the vacuum "T" next to the brake > booster. It is VERY common for this vacuum line to get brittle and > break. Without vacuum the vents will default to the defrost position at > > the windshield. If broken place a piece of small vacuum hose between > the break. If broken at rubber fitting on the end where it goes to the > "T", drill it out and reinsert tube back into rubber and super glue. > > Hope this is helpful, > > > TIM (Musttanguy) > PonyPerformance.com > |
#8
|
|||
|
|||
vacum leak
"richard" > wrote in message news:UXBte.63149$gc6.2562@okepread04... >I have a 1995 mustang v6 the air con works but about two weeks ago it >started to only come out the defrost and floorboard it doen't matter what >the control is set on any suggestions > Rick > |
#9
|
|||
|
|||
"Pete Sampogna" > wrote in news:J0lye.9374$SQ1.2662
@fe09.lga: > vacum leak My buddy took his '96 Contour in to have the tranny rebuilt, and got it back doing the same thing. They had broken a small vacuum line off at the firewall. Look for broken vacuum lines. -- "This space for rent." |
Thread Tools | |
Display Modes | |
|
|