If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Replacing the door latch assembly on 98EB
I have a 98 Explorer with a busted door latch assembly, the spring that
moves the mechanism that unlocks the drivers door has busted. I pulled off the door panel and diagoned the problem and I know that it need a new door latch assembly. But my question is how to get in there and disconnect all of the rods to the one in the door. Is there a particular sequence of rods you have to disconnect first? Thanks |
Ads |
#2
|
|||
|
|||
|
#3
|
|||
|
|||
|
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Headlight assembly removal on '97 Sable: please advise. | [email protected] | Technology | 0 | December 26th 04 05:19 PM |
Advice needed replacing A3 brakerotors and strut mounts. | [email protected] | VW water cooled | 5 | October 22nd 04 05:14 PM |
Replacing Headlight Assembly on 1996 Civic | Roy | Honda | 2 | October 18th 04 04:42 PM |
99 Caravan brake grinding noise even after replacing pads/disks | jogret | Dodge | 4 | October 7th 04 07:49 AM |