Mustang power window bounce back calibration does not workwhen following owners guide. (FIX)

Hello, thought I'd share this fix I found on the Internet for power
windows on 2005 - 2007 Mustangs. This happened to me last week when I
hadn't driven the car for 4 days or so due to the holidays, the damn
battery went partially dead. The owners manual calibration wouldn't work -
it kept bouncing back down instead of calibrating when in the window up
position. Unbelievably, it requires two people to do the job (mutter)
friggin' engineers...


Originally Posted by ford
FORD: 2005-2007 Mustang


ISSUE:
Some 2005-2007 Mustang vehicles may exhibit issues with the functional
power window features including one touch up, short drop, and bounce back.

ACTION:
Follow the Service Procedure steps to correct the condition if the root
cause is incorrect or no window initialization of the Smart Window Motor.

SERVICE PROCEDURE

Perform a de-initialization procedure of the smart motor / side window
glass, followed by re-initialization procedure.

NOTE: WINDOW RE-INITIALIZATION MUST BE PERFORMED WITH THE DOORS CLOSED.



NOTE: ON CONVERTIBLES, WINDOWS COULD BOUNCE BACK IF THE SIDE GLASS IS OUT
OF ADJUSTMENT. REFER TO THE WORKSHOP MANUAL (WSM), SECTION 501-11.



NOTE: CHECK TO MAKE SURE THAT THE DOOR SEAL OR MIRROR SEAL IS NOT ROLLED
OVER OR BINDING. ALSO, THAT THERE IS NO OBSTRUCTION IN GLASS SEALING AREA
AND THE GLASS FIT AND/OR REGULATOR MECHANICAL FASTENING IS NOT LOOSE.



DE-INITIALIZATION PROCEDURE

De-initialization (un-learning) of the smart window motor clears the
memory of the module and shuts off the One-Touch UP, Bounce Back and Short
Drop functions.
The smart window motors can be de-initialized in two (2) different ways:
Disconnect the battery cable from the battery WHILE THE WINDOW IS MOVING.
Remove the window motor fuse from the Power Distribution Box WHILE THE
WINDOW IS MOVING.
After performing one of the above procedures, the smart motor must be
re-initialized, see Initialization Procedure.
INITIALIZATION PROCEDURE

INITIALIZATION MUST BE PERFORMED WITH THE DOOR CLOSED! (For convertibles,
top and the quarter glass must be in the up / closed position.)
From the window switch, perform the following steps without stopping:
Operate the window UP and stall for 2 seconds. (Hold The Switch)
Operate the window DOWN and stall for 2 seconds. (Hold The Switch)
The smart window motor will be initialized and one-touch-UP and Short Drop
will be operational.
Cycle the window glass an additional five (5) times to set the window
"Soft Stop" for the down position.
TIP - VOLTAGE RANGE OF OPERATION: 9-16 VOLTS (AT THE MOTOR)

The smart motor will ONLY function in the 9-16 volt range; if the voltage
at the smart motor drops below 9 volts, the window may not function
properly or prematurely stop moving
If the voltage drops below 9 volts while the motor is moving, the motor
will become de-initialized (one-touch UP and Short Drop will be
inoperable)
If the motor becomes de-initialized due to low voltage, see initialization
procedure. for instructions