If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Wheel adapters ?????
On 6/25/2011 7:35 PM, DougW wrote:
> Newer aircraft aluminum ones are much tougher and line up better > than the old steel plates that in my opinion never should have > been sold. > > A good set is going to run close to $50/wheel. Might want to take > that into account when you price out the rims. i.e. just wait till > you get the rims to mount the tires, then trade the old ones. > Looking at new 6061 aluminum ones. 4 for about $140 so they are give away cost and the tires are already mounted and rubbing a little on tight turns.. -- AJ |
Ads |
#2
|
|||
|
|||
Wheel adapters ?????
On 6/25/2011 7:06 PM, D-R wrote:
> On 6/25/2011 7:35 PM, DougW wrote: > >> Newer aircraft aluminum ones are much tougher and line up better >> than the old steel plates that in my opinion never should have >> been sold. >> >> A good set is going to run close to $50/wheel. Might want to take >> that into account when you price out the rims. i.e. just wait till >> you get the rims to mount the tires, then trade the old ones. >> > > Looking at new 6061 aluminum ones. 4 for about $140 so they are give > away cost and the tires are already mounted and rubbing a little on > tight turns.. > Adjust the wheel stops? Cheaper than the adapters. |
#3
|
|||
|
|||
Wheel adapters ?????
RoyJ wrote:
> On 6/25/2011 7:06 PM, D-R wrote: >> On 6/25/2011 7:35 PM, DougW wrote: >> >>> Newer aircraft aluminum ones are much tougher and line up better >>> than the old steel plates that in my opinion never should have >>> been sold. >>> >>> A good set is going to run close to $50/wheel. Might want to take >>> that into account when you price out the rims. i.e. just wait till >>> you get the rims to mount the tires, then trade the old ones. >>> >> >> Looking at new 6061 aluminum ones. 4 for about $140 so they are give >> away cost and the tires are already mounted and rubbing a little on >> tight turns.. >> > Adjust the wheel stops? Cheaper than the adapters. Seconded. http://project-jk.com/jeep-jk-write-...top-adjustment -- DougW |
#4
|
|||
|
|||
Wheel adapters ?????
On 6/25/2011 11:20 PM, RoyJ wrote:
> Adjust the wheel stops? Cheaper than the adapters. Already have 1 washer in the stop. Not sure if I want to add more and increase the turning radius. I also have a little rubbing in the rear. -- AJ |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
8" Olympic Sleeve Adapters - 2 | [email protected] | BMW | 0 | May 22nd 09 05:30 AM |
source for brass brake like adapters? | David Gravereaux | VW air cooled | 14 | October 1st 08 10:17 PM |
Shop Press for Bushings: Adapters? | Elle | Technology | 7 | May 10th 06 03:11 AM |
Wheel adapters/safe? | Mike West | VW air cooled | 2 | April 7th 06 06:18 AM |
4 lug bug to 5 lug chevy wheel adapters | [email protected] | VW air cooled | 1 | December 14th 04 12:56 AM |