If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
DTC codes
Where at the Alldata site are the tables of DTC codes? My 1996 Grand Voyager is reporting a code of 72 which isn't in the table in my 96 factory service manual (the highest code is 71). I'm assuming that there was a later update to the manual that I don't have. Matt |
Ads |
#2
|
|||
|
|||
Code is catalyst efficiency failure (P0420) in the 97 service manual.
Bill "Matt Whiting" > wrote in message ... > > Where at the Alldata site are the tables of DTC codes? My 1996 Grand > Voyager is reporting a code of 72 which isn't in the table in my 96 > factory service manual (the highest code is 71). I'm assuming that there > was a later update to the manual that I don't have. > > > Matt |
#3
|
|||
|
|||
Bill wrote:
> Code is catalyst efficiency failure (P0420) in the 97 service manual. > > Bill > > "Matt Whiting" > wrote in message > ... > >>Where at the Alldata site are the tables of DTC codes? My 1996 Grand >>Voyager is reporting a code of 72 which isn't in the table in my 96 >>factory service manual (the highest code is 71). I'm assuming that there >>was a later update to the manual that I don't have. >> >> >>Matt > > > Thanks. Any idea how the ECM can tell that the cat isn't working? Matt |
#4
|
|||
|
|||
"Matt Whiting" > wrote in message ... > Bill wrote: > >> Code is catalyst efficiency failure (P0420) in the 97 service manual. >> >> Bill >> >> "Matt Whiting" > wrote in message >> ... >> >>>Where at the Alldata site are the tables of DTC codes? My 1996 Grand >>>Voyager is reporting a code of 72 which isn't in the table in my 96 >>>factory service manual (the highest code is 71). I'm assuming that there >>>was a later update to the manual that I don't have. >>> >>> >>>Matt >> >> >> > > Thanks. Any idea how the ECM can tell that the cat isn't working? > > > Matt Under certain operating conditions (hot engine, steady throttle, minimum speed and engine temp and specific load) the PCM monitors the difference in switching rates between the upstream and the downstream oxygen sensors. Bill |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Codes 19, 26 & 32 on '95 SC2 | Bill | Saturn | 0 | February 27th 05 06:05 PM |
OT - OBD2 Trouble Codes | Jeff Strickland | Jeep | 1 | December 29th 04 06:28 AM |
Ok, now I'm stumped | John Riggs | Ford Explorer | 5 | November 19th 04 05:45 AM |
Tranny Trouble codes | jonnymcfly | Saturn | 4 | July 7th 04 01:41 AM |