If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
2013 Hyundai Sonata - Caster at low end of Spec Range
2013 Hyundai Sonata - Caster at low end of Spec Range:
For this generation of Sonatas(YF 2011 - 14) Caster is specified as +4.4deg, + or - 0.5deg. Mine: L = +3.8, R = +3.9 Question, since caster on my car is nearly dead equal, but is barely at the low end of specified range, #1 how did it check in that low, and #2 is there anything that can be repaired, bent, or replaced to get it up into the middle of that range? Thanks in advance. And yes, I know in *theory* caster and camber cannot be adjusted on a unibody where they are defined by locations of control arms and built in strut tower angles. But is there any way to 'cheat' and add more caster without throwing the other angles off? |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
2009 Hyundai Sonata | john | Honda | 2 | April 4th 08 10:07 AM |
159 Range - No Veloce Spec? | ~ MArky MArk ~ | Alfa Romeo | 1 | June 5th 06 07:10 PM |
AWA [OFFER] Starter: Hyundai Sonata | [email protected] | General | 0 | December 15th 05 01:52 PM |
Hyundai sonata computer codes | Don Dupere via CarKB.com | Technology | 0 | May 14th 05 01:41 PM |
Need 99-01 Hyundai Sonata Floor Mat | Chad Bice | General | 0 | July 12th 04 09:11 PM |