If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
96 Jetta 4cyl/manual AC condenser/radiator support rubbing
Can anyone tell me, what is the normal clearance between the front of the
AC condenser and the upper radiator support vertical member, where it is closest to the condenser (just to the passenger's side of the center of the condenser)? The car I'm working on had some (minor?) damage to the front end, and the condenser is rubbing against the radiator support. The lower radiator support is new but the upper support assembly is original and I believe it may be slightly bent. |
Ads |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
90 Jetta Idle problem on startup / 98 Jetta ignition key question | Lee | VW water cooled | 2 | June 14th 05 12:36 PM |
Is the NEW Jetta as good as it sounds? | [email protected] | VW water cooled | 1 | June 6th 05 02:58 PM |
'95 Jetta III + OBD + clearing code2 | XXninjatooXX | VW water cooled | 3 | April 7th 05 12:23 PM |
2004 Jetta TDI Oil Change Question | tug99 | VW water cooled | 16 | December 1st 04 04:08 AM |