If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
c3 transmission question
On Apr 11, 1:05*pm, " > wrote:
> On Apr 11, 2:01*pm, " > wrote: > > > > > I have a 76 smogger that I have had since new. It has about 120K Miles > > on the clock. > > > I have had the xmission oil changed twice, last one about8-10 years > > ago and maybe 15K miles ago. At that time I had it flushed at the > > dealer - a fairly expensive proposition if I recall correctly. > > > My problem - When the beast is cold, it will not go anywhere for a > > little while until it warms up - the transmission does not seem to > > engage. Once it is warmed up it works fine - no slippage, fairly solid > > shifts, etc. > > > Now I must admit it does not get a lot of use now, so maybe that is > > part of the issue. > > > I am suspecting maybe something needs to be changed or checked, but I > > doubt it is a new tranny. I am thinking it is a case of something > > sticking or being a bit clogged. Or maybe something run through a part > > to be loosened. > > > Any ideas? I have to do a fair amount of work to it this year (new > > composite spring, shocks, brake seals, etc), so am just getting my > > ducks in order for the various things I need to check and repair. > > > TIA - BSA. > > I should also add - when I say cold, I mean weather wise. When it is > sitting in the warm weather in summer, even from a cold start it works > fine. > As an example - today it is maybe 40 degrees and I brought it out of > the garage after its winter hibernation - it had to think a bit before > it would go. That is typical of some of the older trannys. Same thing happened on my 79. Seals start to harden and there is some wear and leakage so it takes a minute or so to warm things up to provide a better seal. Had to start mine and put it in reverse to back out of garage but hold brake while I put on seat belt, etc. In a short bit of time I would feel it start to pull and away we would go. There are some additives that you can add that are specifically for that problem that contain chemicals that will swell the seals. Only problem is that they also soften them enough that they wear more, faster. That means a rebuild is near. Good Luck PDDeen |
Ads |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
c3 transmission question | [email protected][_2_] | Corvette | 0 | April 11th 09 07:05 PM |
transmission question | Jacob | Ford Explorer | 6 | March 6th 05 03:38 PM |
Transmission question | Rob | Honda | 3 | February 2nd 05 05:37 AM |
'04 Transmission Question | dicko | Ford Explorer | 4 | November 14th 04 12:40 AM |
98 Jetta: timing belt question-non-interference?/transmission fluid question | Ben867-5309 | VW water cooled | 1 | October 20th 04 03:53 PM |