If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#11
|
|||
|
|||
"Spiderman" > wrote in message >...
> I have a 1989 Chevy S10 Blazer that blows out warm A/C. It's > low on R12 so the compressor just cycles on/off. I'm gonna top > it off with R12. Is a gauge necessary or can I just play it > "by air". Try the forums at www.aircondition.com, a place dedicated to car A/C. People who know better than me are going to hate what I'm about to say, but if nothing else is wrong with the A/C you can get the R-12 charge about right if you monitor the inlet and outlet pipe temperatures of the evaporator while the engine runs at fast idle (must be fast, and run the engine at least 10 minutes before charging) and you slowly (emphasis on "slowly") put in R-12 until the outlet is almost as cold as the inlet. Ideally they should be equal, but it's safer to undercharge than overcharge. > Where can I find the normal low-side, high-side pressure ranges? Any car repair manual that covers GM vehicles since they went to orfice tubes? |
Ads |
#12
|
|||
|
|||
On Wed, 2 Jun 2004, Spiderman wrote:
> I have a 1989 Chevy S10 Blazer that blows out warm A/C. It's low on R12 ....because it's got the GM R4 compressor that loses shaft seals on a regular basis. R12 is available, but expensive, and top-up charges will not last. You will very quickly spend a lot more in R12 (to say nothing of tools and manuals to put it in properly) than to fix the problem correctly. -Stern |
#13
|
|||
|
|||
On Wed, 2 Jun 2004, Spiderman wrote:
> I have a 1989 Chevy S10 Blazer that blows out warm A/C. It's low on R12 ....because it's got the GM R4 compressor that loses shaft seals on a regular basis. R12 is available, but expensive, and top-up charges will not last. You will very quickly spend a lot more in R12 (to say nothing of tools and manuals to put it in properly) than to fix the problem correctly. -Stern |
#14
|
|||
|
|||
On Wed, 2 Jun 2004 01:21:18 -0400, "Refinish King"
> wrote: ||Get caught by a local EPA agent: It would be a lot harder to find an EPA field enforcement agent, much less one that is interested in a DIY guy buying 3 cans of "contraband" from an individual. It's not even on their radar screen. I have never heard of any prosecution from this law, ever. Texas Parts Guy |
#15
|
|||
|
|||
On Wed, 2 Jun 2004 01:21:18 -0400, "Refinish King"
> wrote: ||Get caught by a local EPA agent: It would be a lot harder to find an EPA field enforcement agent, much less one that is interested in a DIY guy buying 3 cans of "contraband" from an individual. It's not even on their radar screen. I have never heard of any prosecution from this law, ever. Texas Parts Guy |
#16
|
|||
|
|||
Back when 12 or 14 ounce cans of R12 were less than $2 each and nobody worried about the ozone layer I would add refrigerant until it started blowing cool air and then add one more can. Spiderman wrote: > > I have a 1989 Chevy S10 Blazer that blows out warm A/C. It's low on R12 so > the compressor just cycles on/off. I'm gonna top it off with R12. Is a gauge > necessary or can I just play it "by air". Where can I find the normal > low-side, high-side pressure ranges? -- When replying by Email include NewSGrouP (case sensitive) in Subject Mike Walsh West Palm Beach, Florida, U.S.A. |
#17
|
|||
|
|||
Back when 12 or 14 ounce cans of R12 were less than $2 each and nobody worried about the ozone layer I would add refrigerant until it started blowing cool air and then add one more can. Spiderman wrote: > > I have a 1989 Chevy S10 Blazer that blows out warm A/C. It's low on R12 so > the compressor just cycles on/off. I'm gonna top it off with R12. Is a gauge > necessary or can I just play it "by air". Where can I find the normal > low-side, high-side pressure ranges? -- When replying by Email include NewSGrouP (case sensitive) in Subject Mike Walsh West Palm Beach, Florida, U.S.A. |
#18
|
|||
|
|||
Come to the Island:
Northumberland County Pennsylvania. Where they will prosecute you for wearing pants "Gangsta" style. (Not that I think that's a bad reason to prosecute for!) But out here, They'll prosecute you for farting! Air pollution! Unless you're on the correct political parties registration list! Refinish King "Rex B" > wrote in message ... > On Wed, 2 Jun 2004 01:21:18 -0400, "Refinish King" > > wrote: > > ||Get caught by a local EPA agent: > > It would be a lot harder to find an EPA field enforcement agent, much less one > that is interested in a DIY guy buying 3 cans of "contraband" from an > individual. It's not even on their radar screen. I have never heard of any > prosecution from this law, ever. > Texas Parts Guy |
#19
|
|||
|
|||
Come to the Island:
Northumberland County Pennsylvania. Where they will prosecute you for wearing pants "Gangsta" style. (Not that I think that's a bad reason to prosecute for!) But out here, They'll prosecute you for farting! Air pollution! Unless you're on the correct political parties registration list! Refinish King "Rex B" > wrote in message ... > On Wed, 2 Jun 2004 01:21:18 -0400, "Refinish King" > > wrote: > > ||Get caught by a local EPA agent: > > It would be a lot harder to find an EPA field enforcement agent, much less one > that is interested in a DIY guy buying 3 cans of "contraband" from an > individual. It's not even on their radar screen. I have never heard of any > prosecution from this law, ever. > Texas Parts Guy |
#20
|
|||
|
|||
I thought I have heard recently that you can buy R12 almost anywhere is US?
"Spiderman" > wrote in message ... > R-12 is easy to get. > > > "Robert Hancock" > wrote in message > news:Tfdvc.646141$Ig.552932@pd7tw2no... > > Yes, you're going to need gauges to do it properly. And unless you're a > > certified A/C tech, most likely you're not going to be able to get hold of > > any R-12.. > > > > -- > > Robert Hancock Saskatoon, SK, Canada > > To email, remove "nospam" from > > Home Page: http://www.roberthancock.com/ > > > > > > "Spiderman" > wrote in message > > ... > > > I have a 1989 Chevy S10 Blazer that blows out warm A/C. It's low on R12 > so > > > the compressor just cycles on/off. I'm gonna top it off with R12. Is a > > gauge > > > necessary or can I just play it "by air". Where can I find the normal > > > low-side, high-side pressure ranges? > > > > > > > > > > > > |
Thread Tools | |
Display Modes | |
|
|