If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Belt tensioner 94 SL2
I need to replace serpentine belt tensioner. Is it really necessary to
remove the right upper mount as Chilton recommends? -- MP |
Ads |
#2
|
|||
|
|||
Jack up front of car and remove the right front wheel. Remove the clips
holding the plastic inner fender and move it out of the way. Now the tensioner is easy to see and remove. I do recall having to use a swivel socket to get to the upper bolt. Good Luck, James |
#3
|
|||
|
|||
Thanks, it worked
James1549 wrote: > Jack up front of car and remove the right front wheel. Remove the clips > holding the plastic inner fender and move it out of the way. Now the > tensioner is easy to see and remove. I do recall having to use a swivel > socket to get to the upper bolt. Good Luck, James > |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Unbelievable: Belt will not fit on new tensioner! | Julie P. | Technology | 30 | September 30th 05 05:52 AM |
timing belt tension | Ryan Underwood | Technology | 14 | September 25th 05 12:13 AM |
question about timing belt tensioner | [email protected] | Technology | 6 | September 19th 05 07:41 PM |
tensioner for sert. belt needed?? | mac | Technology | 1 | July 26th 05 12:28 AM |
1991 Accord Balance Shafts Belt Tensioner | Ryan | Honda | 1 | May 28th 05 04:22 AM |