If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
98 Intrepid oil light flickers at idle when engine hot
I have read there is a TSB (08-36-99) on this problem that I have been
experiencing lately. I have purchased the wire terminal/vent p/n 05017800AA mentioned in the TSB and I want to install it myself. I would like to know the location of the oil pressure switch on the 2.7L engine. I have looked under the engine (passenger's side) and I see 3 units. From the firewall towards the front of the car they a a black one, an orange one and a green one (these are the connectors' colors). I suspect the green one is the oil pressure switch but I'm not sure. If it is the one, how do I remove the switch connector from the switch? Something seems to lock it in place and I can't see the typical plastic tabs. If anyone has experience with this could you please share it. Thanks much, Dan |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Strattus with check engine light on | Pops | Dodge | 4 | November 17th 04 12:22 AM |
rec.autos.makers.chrysler FAQ, Part 1/6 | Dr. David Zatz | Chrysler | 10 | November 16th 04 05:28 AM |
rec.autos.makers.chrysler FAQ, Part 1/6 | Dr. David Zatz | Chrysler | 10 | November 1st 04 05:24 AM |
rec.autos.makers.chrysler FAQ, Part 1/6 | Dr. David Zatz | Chrysler | 10 | October 16th 04 05:28 AM |