If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
1934/'34 Plymouth Business Coupe Trunk Handle WANTED!!!
Fellow Car Enthusiast,
We are looking to BUY a specific style trunk handle/lock for a '34 Plymouth Business Coupe. The lock is for a car under restoration. The early version used the bent key cylinder. Then later in '34 was supplied & finally the trunk handle/lock was decided upon as the best. This trunk handle is 3-3/8th inches wide and 4-3/8th inches long. And probably approxiatmately 1 to 2 inches thick. We are looking for any of the 3, bent key version, straight key version, or trunk handle/lock version. Does anyone have ANY THING!.. N.O.S., Used, No Key?... Etc? Also wanted is the mounting flange for the trunk handle/lock. Please contact me here with any information: Thank you for your time. -Joanna |
Ads |
#3
|
|||
|
|||
That's a great idea and I may steal it for the handle that I need to
fabricate for the rumble seat in my '31 Studebaker President State coupe. JT wrote: > > If it's the same as my 39 Ply, then the shaft that goes into the lock > is square (5/16 I think). I found a handle at a harware store - used > for garage doors, that was nicely shaped and not too modern looking. > Walk down your back lane and pay attention to the overhead door > opening handles. You may be able to work a deal with a neighbour. > > The mount plate I had and I merely mounted the new handle to it - some > modification. I may have an extra mount plate circa 1950 tha may do > the job for you if you think you want it - first measure the spread > between the two screw holes. > > Pete > > On 22 May 2004 12:58:43 -0700, (Joanna) wrote: > > >Fellow Car Enthusiast, > >We are looking to BUY a specific style trunk handle/lock for a '34 > >Plymouth Business Coupe. The lock is for a car under restoration. > > > >The early version used the bent key cylinder. Then later in '34 was > >supplied & finally the trunk handle/lock was decided upon as the best. > > This trunk handle is 3-3/8th inches wide and 4-3/8th inches long. > >And probably approxiatmately 1 to 2 inches thick. > > > >We are looking for any of the 3, bent key version, straight key > >version, or trunk handle/lock version. > > > >Does anyone have ANY THING!.. N.O.S., Used, No Key?... Etc? > > > >Also wanted is the mounting flange for the trunk handle/lock. > > > >Please contact me here with any information: > > > >Thank you for your time. > >-Joanna - |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
New *FREE* Corvette Discussion Forum | JLA ENTERPRISES TECHNOLOGIES INTEGRATION | Corvette | 12 | November 30th 04 06:36 PM |