If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
96 voyager stalled and crank but wont turnover.
1996 grand voyager 3.3L engine. Friend driving and the van sputter and
stalls out. It cranks but wont turnover. I know the engine is running lean because of a bad O2 sensor. What could the problem be. What area[s] should I investigate. Any help is appreciated |
Ads |
#2
|
|||
|
|||
96 voyager stalled and crank but wont turnover.
On Mon, 06 Nov 2006 19:47:42 -0800, pchotspot wrote:
> 1996 grand voyager 3.3L engine. Friend driving and the van sputter and > stalls out. It cranks but wont turnover. I know the engine is running > lean because of a bad O2 sensor. What could the problem be. What > area[s] should I investigate. Any help is appreciated Gee...., you think it might be the bad O2 sensor...? -- "Ubuntu" - an African word meaning "Slackware is too hard for me". |
#3
|
|||
|
|||
96 voyager stalled and crank but wont turnover.
Dan C..................pleaseeeeeeeeeeeeeeeeeeeeeeee DO NOT RESPOND TO
ANY OF MY POSTING................... YOU ARE AN ASS! Dan C wrote: > On Mon, 06 Nov 2006 19:47:42 -0800, pchotspot wrote: > > > 1996 grand voyager 3.3L engine. Friend driving and the van sputter and > > stalls out. It cranks but wont turnover. I know the engine is running > > lean because of a bad O2 sensor. What could the problem be. What > > area[s] should I investigate. Any help is appreciated > > Gee...., you think it might be the bad O2 sensor...? > > -- > "Ubuntu" - an African word meaning "Slackware is too hard for me". |
#4
|
|||
|
|||
96 voyager stalled and crank but wont turnover.
has nothing to do with the 02 sensor, go back to basics..does it has spark?
is it getting fueL I assume that the check emgine lite is on due to the 02 sensor, are there any other fault codes? Glenn beasley Chrysler Tech |
#5
|
|||
|
|||
96 voyager stalled and crank but wont turnover.
i checked for spark and there is none. I also remove the ignition coil
from another van [96 caravan 3.3] that cranks, and put it in but the van [96 voyager 3.3] that does not crank. AND THE VAN DID NOT CRANK! i actually switch the two coils, and the coil from the 96 VOYAGER 3.3L did not crank in the 96 CARAVAN 3.3L. [so I assume that coil is bad]. But when I put the good coil FROM THE 96 CARAVAN that did not crank in the [96 voyager 3.3]. when I switch them back the 96 caravan cranked and the 96 voyager did not. the 02 sensor is bad and i dont know if that causing the coil to not get electricity. If someone can tell me where to check as to why the coil pack is not getting spark I would appreciate it very much. damnnickname wrote: > has nothing to do with the 02 sensor, go back to basics..does it has spark? > is it getting fueL I assume that the check emgine lite is on due to the 02 > sensor, are there any other fault codes? > > Glenn beasley > Chrysler Tech |
#6
|
|||
|
|||
96 voyager stalled and crank but wont turnover.
"pchotspot" > wrote in message oups.com... > i checked for spark and there is none. I also remove the ignition coil > from another van [96 caravan 3.3] that cranks, and put it in but the > van [96 voyager 3.3] that does not crank. AND THE VAN DID NOT CRANK! i > actually switch the two coils, and the coil from the 96 VOYAGER 3.3L > did not crank in the 96 CARAVAN 3.3L. [so I assume that coil is bad]. > But when I put the good coil FROM THE 96 CARAVAN that did not crank in > the [96 voyager 3.3]. when I switch them back the 96 caravan cranked > and the 96 voyager did not. > > the 02 sensor is bad and i dont know if that causing the coil to not > get electricity. If someone can tell me where to check as to why the > coil pack is not getting spark I would appreciate it very much. > > > damnnickname wrote: > > has nothing to do with the 02 sensor, go back to basics..does it has spark? > > is it getting fueL I assume that the check emgine lite is on due to the 02 > > sensor, are there any other fault codes? > > > > Glenn beasley > > Chrysler Tech > Your gonna have to stick with one post and reply to that and not keep making new post and sending e mail, its to confusing. Since you are able to check fault codes I would assume the PCM is more then likely ok but could still be causing the problem. The fuel pump is the only thing that wont set a fault code when it goes bad and if the PCM heat sink goes bad you will not get a fault Before you do anything else, take the air cleaner snorkel of the throttle body and open the blade, spray a shot of gum cutter or throttle body cleaner in it and try to start it. |
#7
|
|||
|
|||
96 voyager stalled and crank but wont turnover.
you said you have no spark so check for power on coil if it checks out check
for the ground on coil witch shoud go on and of to build voltage for the spark" if not check cranksensor" and stick to basics fuel+aircompression on timing+spark on timin= run Chrysler Tech T.R "maxpower" > wrote in message ... > > "pchotspot" > wrote in message > oups.com... >> i checked for spark and there is none. I also remove the ignition coil >> from another van [96 caravan 3.3] that cranks, and put it in but the >> van [96 voyager 3.3] that does not crank. AND THE VAN DID NOT CRANK! i >> actually switch the two coils, and the coil from the 96 VOYAGER 3.3L >> did not crank in the 96 CARAVAN 3.3L. [so I assume that coil is bad]. >> But when I put the good coil FROM THE 96 CARAVAN that did not crank in >> the [96 voyager 3.3]. when I switch them back the 96 caravan cranked >> and the 96 voyager did not. >> >> the 02 sensor is bad and i dont know if that causing the coil to not >> get electricity. If someone can tell me where to check as to why the >> coil pack is not getting spark I would appreciate it very much. >> >> >> damnnickname wrote: >> > has nothing to do with the 02 sensor, go back to basics..does it has > spark? >> > is it getting fueL I assume that the check emgine lite is on due to the > 02 >> > sensor, are there any other fault codes? >> > >> > Glenn beasley >> > Chrysler Tech >> > Your gonna have to stick with one post and reply to that and not keep > making > new post and sending e mail, its to confusing. > Since you are able to check fault codes I would assume the PCM is more > then > likely ok but could still be causing the problem. The fuel pump is the > only > thing that wont set a fault code when it goes bad and if the PCM heat sink > goes bad you will not get a fault Before you do anything else, take the > air > cleaner snorkel of the throttle body and open the blade, spray a shot of > gum > cutter or throttle body cleaner in it and try to start it. > > |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Crank Case Sensor and rare stalling | Treeline | Chrysler | 5 | March 28th 05 12:16 AM |