A Cars forum. AutoBanter

If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below.

Go Back   Home » AutoBanter forum » Auto makers » Dodge
Site Map Home Register Authors List Search Today's Posts Mark Forums Read Web Partners

Centering an engine



 
 
Thread Tools Display Modes
  #1  
Old October 23rd 06, 07:28 PM posted to alt.autos.dodge
Lynn in StLou
external usenet poster
 
Posts: 1
Default Centering an engine

I know from my experience with my old 2.2 turbo Dodges that
centering the engine is important to prevent premature
failure of the drive shafts and vibration. That was with
equal length half-shafts. My question is this: Does a
vehicle not using equal length half-shafts need to have its
engine centered for the same reasons. I ask this because my
jobber is trying to run down a vibration after replacing a
drive shaft and some motor mounts on my 92 Caravan with a 3.3L.

Thanks
--
Lynn in StLou
REMOVETHIS anti-spam measure to reply
Ads
 




Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

vB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Forum Jump

Similar Threads
Thread Thread Starter Forum Replies Last Post
Recommendations for Jeep Mechanic near Edison, NJ [email protected] Jeep 1 July 30th 06 07:10 PM
Why you should never buy a car without a tachometer Ted B. Driving 112 September 19th 05 04:09 AM
rec.autos.makers.chrysler FAQ, Part 1/6 Dr. David Zatz Chrysler 3 February 18th 05 06:34 AM
rec.autos.makers.chrysler FAQ, Part 1/6 Dr. David Zatz Chrysler 4 February 2nd 05 06:22 AM
rec.autos.makers.chrysler FAQ, Part 1/6 Dr. David Zatz Chrysler 10 December 18th 04 06:15 AM


All times are GMT +1. The time now is 12:20 PM.


Powered by vBulletin® Version 3.6.4
Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.
Copyright ©2004-2024 AutoBanter.
The comments are property of their posters.