|If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below.|
||Thread Tools||Display Modes|
My 94 SC2 DOHC 130K miles is starting to make low frequency noise and
vibration. After sitting overnite (cold) , after starting and putting gear
in reverse an odd rumble/growl/vibration occurs when idling stopped. If I
let off brake and start rolling in reverse it ceases until I stop again.
After a few minutes of running the majority of this noise will clear out.
This has been happening for a couple of weeks now. Also now the foward
gear is making this low rumble noise especially at highway speeds. 6
months ago I replaced the upper T axis mount because the steering wheel at
idle vibrated so bad I couldn't stand it any more. The new mount made it
seem like a new car. I'm wondering if the lower mount or the transaxle
mounts could be bad. Has any one had these replaced --how many miles?
Is this something a shade tree mechanic (me) can tackle with limit tools
The tranny shifts and functions OK but if I let this continue driveline
components might be damaged?
Fluid was changed 15K miles ago and levels are OK.
Any help much appreciated.
|Thread||Thread Starter||Forum||Replies||Last Post|
|Vibration/noise when turning left||Rock||Saturn||6||September 21st 04 08:24 AM|
|2000 SL1 vibration/noise in front end||bearcat500||Saturn||3||June 13th 04 12:10 AM|