|If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below.|
||Thread Tools||Display Modes|
BMW 325E (e30) Window travel adjustment question
On Friday, November 18, 2016 at 8:59:02 AM UTC-5, Scott Dorsey wrote:
> > wrote:
> >On Sunday, October 31, 1999 at 3:00:00 AM UTC-4, Popeye wrote:
> >> Do you own a hammer?
> >> Lorestat wrote
> >> >The window on the passenger side of my elder BMW does not fully retract
> >> into
> >> >the door. It sticks up about 1" or so. Does anyone know an easy way to make
> >> >this adjustment and or where I might be able to find the procedure on how
> >> to do
> >> >it?
> >> >
> >> >Thanks..
> >> >Lorestat
> >And you thinks that's funny?? Why??
> Well... it was nearly twenty years ago that was posted. So it's a bit late
> to worry about it now.
> But why it is funny is because the original poster clearly had a failed
> regulator (and likely it's because the delrin teeth have become chopped
> off) but believed that there's some simple adjustment that will fix it.
> "C'est un Nagra. C'est suisse, et tres, tres precis."
I'd say that I was .. hoping it would have been an adjustment... Just sayin!!
|Thread||Thread Starter||Forum||Replies||Last Post|
|Travel National Holidays around Asia in 2009 Asia holidays. Vacations& holidays in Asia 2009 Travel. World's best holidays 2009 Travel. Diving inAsia 2009 Travel. Asia scuba diving holidays 2009 Travel. World's best diving2009 Travel. Full Moon B||Languagecorps Cambodia||Driving||0||December 29th 08 05:23 AM|
|window regulator adjustment on cabrio?||Bill Kearney||VW water cooled||1||May 11th 06 10:19 PM|
|Air Flow Meter Adjustment 325e||[email protected]||BMW||2||September 11th 05 03:34 AM|
|question: timing belts adjustment||Nemo||Honda||7||September 2nd 05 06:19 PM|
|e36 clutch pedal adjustment question||P-u-h-e-k||BMW||1||October 11th 04 11:41 PM|