If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
1967 ford mustang motor replacement
Can anyone tell me if a 250 6 cylinder will fit in a 67 mustang. A 200
6 cylinder came out of it -- Posted using the http://www.autoforumz.com interface, at author's request Articles individually checked for conformance to usenet standards Topic URL: http://www.autoforumz.com/1967-ford-...ict148781.html Visit Topic URL to contact author (reg. req'd). Report abuse: http://www.autoforumz.com/eform.php?p=715372 |
Ads |
#2
|
|||
|
|||
1967 ford mustang motor replacement
Should be pretty feasible but not a simple matter of just stabbing 'er
right in there. Someone pointed to this page in the course of correcting a mistake I made awhile back: http://www.fordsix.com/tech/engine/200_swap.php Best of luck, --Joe |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
William Clay Ford Jr. - Not your great-grandfather's Ford. | Grover C. McCoury III | Ford Mustang | 8 | April 24th 05 09:04 PM |
Mustang Kicks GTO Butt | [email protected] | Ford Mustang | 14 | April 21st 05 01:34 AM |
FORD TO INCREASE MUSTANG PRODUCTION TO MEET RUNAWAY CONSUMER DEMAND | Grover C. McCoury III | Ford Mustang | 1 | March 23rd 05 11:08 PM |
Mustang Returns to Sports Car Racing | Grover C. McCoury III | Ford Mustang | 0 | January 29th 05 05:39 PM |
21st Century Goat vs Mustang Shootout | [email protected] | Ford Mustang | 1 | January 15th 05 06:09 PM |