If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Intake Manifold for Autostick Tranny
Can anyone tell me how the main vacuum line from the autostick tranny
control valve attaches to the intake manifold? The intake manifold is on 72' dual port type 1. I'm looking for that part or how that vacuum seal is maintained. Thanks Scott |
Ads |
#2
|
|||
|
|||
|
#3
|
|||
|
|||
>>Can anyone tell me how the main vacuum line from the autostick tranny
>>control valve attaches to the intake manifold? The intake manifold is >>on 72' dual port type 1. I'm looking for that part or how that vacuum >>seal is maintained. I just replaced the lines in a 71 autostick bought some hydrolic line was about $25 for all three. and you clamp it at both ends. Mario |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
M30 Intake Manifold | Bill | BMW | 6 | November 21st 04 11:39 AM |
Intake Manifold Recommendation - Torker? | [email protected] | Corvette | 7 | August 25th 04 06:07 PM |
2.5 L EFI Intake Manifold - Donavan's Suggestion | Andrew Perlow | Dodge | 2 | August 20th 04 10:11 PM |