If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
1998 SL2 hesitates when stepping on gas pedal
We have a 1998 SL2 with 105K miles. Recently it started hesitating
when stepping on the gas pedal quickly. When idling it wants to stall. When moving along and stepping on the pedal it stutters for a moment. SES light is off. Engine runs cold (thermostat replacement as soon as it's warm enough out) and idles at 1500 RPM. Any ideas? The stutter reminds me of vaccum leaks back in the distributor/rotor days or a bad carb. Thanks! |
Ads |
#2
|
|||
|
|||
1998 SL2 hesitates when stepping on gas pedal
In article >, somebody > wrote:
>We have a 1998 SL2 with 105K miles. Recently it started hesitating >when stepping on the gas pedal quickly. When idling it wants to >stall. When moving along and stepping on the pedal it stutters for a >moment. > >SES light is off. Engine runs cold (thermostat replacement as soon as >it's warm enough out) and idles at 1500 RPM. > >Any ideas? The stutter reminds me of vaccum leaks back in the >distributor/rotor days or a bad carb. Have you checked for vacuum leaks? |
#3
|
|||
|
|||
1998 SL2 hesitates when stepping on gas pedal
I had the same problem with my 98 SL2 cleaned the throttle and now it runs
fine. |
#4
|
|||
|
|||
1998 SL2 hesitates when stepping on gas pedal
"somebody" > wrote in message ... > We have a 1998 SL2 with 105K miles. Recently it started hesitating > when stepping on the gas pedal quickly. When idling it wants to > stall. When moving along and stepping on the pedal it stutters for a > moment. > > SES light is off. Engine runs cold (thermostat replacement as soon as > it's warm enough out) and idles at 1500 RPM. > > Any ideas? The stutter reminds me of vaccum leaks back in the > distributor/rotor days or a bad carb. > > Thanks! If the engine always runs cold, it will be running rich, uses fuel and possibly floods on accel. Most of the codes are set when the engine is at operating temperature. If it never thinks it has warmed up, codes may not be set. I'd replace the thermostat and if symptoms persist, have it checked with a scanner (much more comprehensive than a code reader). Then there's always the possibility that the SES light is blown out. Do you get the check engine and service lights at key-on lamp check? Oppie |
#5
|
|||
|
|||
1998 SL2 hesitates when stepping on gas pedal
On Fri, 15 Jan 2010 15:06:52 -0500, "Oppie" >
wrote: > > >"somebody" > wrote in message .. . >> We have a 1998 SL2 with 105K miles. Recently it started hesitating >> when stepping on the gas pedal quickly. When idling it wants to >> stall. When moving along and stepping on the pedal it stutters for a >> moment. >> >> SES light is off. Engine runs cold (thermostat replacement as soon as >> it's warm enough out) and idles at 1500 RPM. >> >> Any ideas? The stutter reminds me of vaccum leaks back in the >> distributor/rotor days or a bad carb. >> >> Thanks! > >If the engine always runs cold, it will be running rich, uses fuel and >possibly floods on accel. > >Most of the codes are set when the engine is at operating temperature. If it >never thinks it has warmed up, codes may not be set. >I'd replace the thermostat and if symptoms persist, have it checked with a >scanner (much more comprehensive than a code reader). > >Then there's always the possibility that the SES light is blown out. Do you >get the check engine and service lights at key-on lamp check? > >Oppie I'm having the thermostat replaced tomorrow, too cold out to mess with it myself. All the vacuum hoses look OK, and the engine runs OK for the first few minutes, until the car warms up a little. The SES came on with low coolant temperature. We'll find out soon. Thanks for the replies! |
#6
|
|||
|
|||
1998 SL2 hesitates when stepping on gas pedal
On Fri, 15 Jan 2010 05:44:40 -0500, "Bill" > wrote:
>I had the same problem with my 98 SL2 cleaned the throttle and now it runs >fine. > How did you clean it and what brand was the stuff? |
#7
|
|||
|
|||
1998 SL2 hesitates when stepping on gas pedal
On Fri, 15 Jan 2010 15:06:52 -0500, "Oppie" >
wrote: > > >"somebody" > wrote in message .. . >> We have a 1998 SL2 with 105K miles. Recently it started hesitating >> when stepping on the gas pedal quickly. When idling it wants to >> stall. When moving along and stepping on the pedal it stutters for a >> moment. >> >> SES light is off. Engine runs cold (thermostat replacement as soon as >> it's warm enough out) and idles at 1500 RPM. >> >> Any ideas? The stutter reminds me of vaccum leaks back in the >> distributor/rotor days or a bad carb. >> >> Thanks! > >If the engine always runs cold, it will be running rich, uses fuel and >possibly floods on accel. > >Most of the codes are set when the engine is at operating temperature. If it >never thinks it has warmed up, codes may not be set. >I'd replace the thermostat and if symptoms persist, have it checked with a >scanner (much more comprehensive than a code reader). > >Then there's always the possibility that the SES light is blown out. Do you >get the check engine and service lights at key-on lamp check? > >Oppie Replaced the thermostat today. The SES light went out and there's lots of heat. But the temperature gauge doesn't move a bit and it still stalls/hesitates. Is there a quick test for the temperature sensor? |
#8
|
|||
|
|||
1998 SL2 hesitates when stepping on gas pedal
On Sat, 16 Jan 2010 12:13:14 -0500, somebody >
wrote: >On Fri, 15 Jan 2010 15:06:52 -0500, "Oppie" > >wrote: > >> >> >>"somebody" > wrote in message . .. >>> We have a 1998 SL2 with 105K miles. Recently it started hesitating >>> when stepping on the gas pedal quickly. When idling it wants to >>> stall. When moving along and stepping on the pedal it stutters for a >>> moment. >>> >>> SES light is off. Engine runs cold (thermostat replacement as soon as >>> it's warm enough out) and idles at 1500 RPM. >>> >>> Any ideas? The stutter reminds me of vaccum leaks back in the >>> distributor/rotor days or a bad carb. >>> >>> Thanks! >> >>If the engine always runs cold, it will be running rich, uses fuel and >>possibly floods on accel. >> >>Most of the codes are set when the engine is at operating temperature. If it >>never thinks it has warmed up, codes may not be set. >>I'd replace the thermostat and if symptoms persist, have it checked with a >>scanner (much more comprehensive than a code reader). >> >>Then there's always the possibility that the SES light is blown out. Do you >>get the check engine and service lights at key-on lamp check? >> >>Oppie > >Replaced the thermostat today. The SES light went out and there's >lots of heat. > >But the temperature gauge doesn't move a bit and it still >stalls/hesitates. Is there a quick test for the temperature sensor? A $10.00 ECTS (engine coolant temperature sensor) took care of the temperature gauge and now it runs fine. The original was the plastic version and it had a crack in it. Will change the oil becaus it's due and we're done for the day. Thanks for all who replied! |
#9
|
|||
|
|||
1998 SL2 hesitates when stepping on gas pedal
"somebody" > wrote in message ... > A $10.00 ECTS (engine coolant temperature sensor) took care of the > temperature gauge and now it runs fine. The original was the plastic > version and it had a crack in it. Will change the oil becaus it's due > and we're done for the day. > > Thanks for all who replied! Lucky guess. The engine controller 'learns' and adapts (to an extent, at least). Often times, when you fix one thing, you have to either reset the controller (remove the battery cable to dump memory or by OBDII) or wait for it to re-learn the new conditions. Glad it all worked out for you. -Oppie |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Cerberus stepping up efforts to sell Chrysler | Jim Higgins | Chrysler | 0 | October 17th 08 11:50 AM |
Someone stepping up to the plate | JohnH | Driving | 28 | May 13th 06 06:08 PM |
Soft brake pedal/excessive pedal pressure - 2001 Intrepid w/ABS | Phil T | Chrysler | 0 | April 23rd 06 02:52 AM |
High pitched noise when stepping on gas pedal | [email protected] | Technology | 5 | February 17th 06 10:58 PM |
95 saturn SL2, stepping on the break pedal, it goes in soft and deep into the floor... | John Doe | Saturn | 6 | March 6th 05 04:15 PM |