If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
HELP -- 1992 XLT starts and runs great UNTIL YOU RELEASE THE KEY
My 1992 Ford Explorer XLT (4.0L V6, automatic, tilt wheel) starts and runs, but when the key is released and springs back to "run" position, the engine dies.
While holding the key between "start" and "run", the engine runs but the electrics (blower motor, wipers) don't work. I replaced the IGNITION SWITCH, but that changed nothing. Could it be the IGNITION ACTUATOR ROD? I tried several times to adjust the switch position before tightening it down, but nothing made a difference. Once the key is released, the engine dies...but the electrics come on. What might cause this, what might fix it? |
Ads |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Starts after it clicks runs 20 mins and quits. | Kidder007 | Dodge | 0 | May 30th 05 05:19 PM |
car starts runs 5-10 seconds | terry l demerchant | Chrysler | 5 | May 10th 05 08:08 PM |
Wrangler starts, runs for 3 seconds? | ElAlumbrado | Jeep | 17 | March 19th 05 01:53 AM |
Wrangler starts, runs for 3 seconds? | ElAlumbrado | Technology | 8 | March 19th 05 01:53 AM |
96 SW1, runs great, then terrible | Chuck Connell | Saturn | 1 | December 21st 04 04:42 AM |