If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Dellorto carb problem
Hi
Trying to set the idle screws on the carbs the other day, and I adjusted all of them apart from one. The idle screw for number three cylinder does not affect the engine at all, no matter how far I screw it in or out. I checked the idle jet, which I thought maybe blocked, but it is fine. What could the problem be? I have also noticed when the engine is idling, it sounds as though it is missing, and it is the same under light throttle. But when I put my foot down it picks up and goes great. Have I got a blockage somewhere in the idle circuit? What can I do to remedy this? Cheers |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Dellorto carbs linkage problem | Tony Wilkinson | VW air cooled | 2 | December 7th 04 08:44 PM |
rec.autos.makers.chrysler FAQ, Part 1/6 | Dr. David Zatz | Chrysler | 10 | December 2nd 04 05:19 AM |
New *FREE* Corvette Discussion Forum | JLA ENTERPRISES TECHNOLOGIES INTEGRATION | Corvette | 12 | November 30th 04 06:36 PM |
87 TBI Suburban bog / acceleration problem | Michael Vosk | 4x4 | 8 | September 29th 04 04:55 AM |
Ion intermittent ignition switch problem | ELY | Saturn | 3 | August 14th 04 03:18 AM |