If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Back window install
Hey guys and gals,
I have a 1976 corvette with T-tops I'm restoring. How is the back window held in? Is it just held in by the seal and the plastic rear window molding? Am I missing something?? Cornfused |
Ads |
#2
|
|||
|
|||
Back window install
"Stephen Sadler" > wrote in message news:4d0e2f52 > I have a 1976 corvette with T-tops........... Be thankful for those T-tops. The last convertables were made in 1975, so without those T-tops, your '76 would have nothing up there to keep the rain out. But seriously... I'm not positive of the answer. I *think* just the seal (with adhesive) and the molding. -W |
#3
|
|||
|
|||
Back window install
"Stephen Sadler" > wrote in message ... > Hey guys and gals, > > I have a 1976 corvette with T-tops I'm restoring. How is the back > window held in? Is it just held in by the seal and the plastic rear > window molding? Am I missing something?? > Nope, you're pretty much on track. Be aware that the rope seal comes in different diameters and you should have better luck with the proper diameter. It's held in pretty much just like the windshields of that era so if done properly it will seal and look original. Care is needed when you put it in location as it will be very difficult to move to correct any mis-location, like, nearly impossible. Good luck |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
'66 door window install question | Mark C. | Ford Mustang | 1 | September 1st 06 07:09 PM |
Difficult to put current motor in new window regulator and install in door? | New At This | Honda | 0 | August 26th 06 07:56 AM |
1975 Stingray power window regulator install | DaveG | Corvette | 0 | April 24th 06 11:30 PM |
Vent window seal install instructions | Papa | VW water cooled | 0 | April 8th 05 02:11 AM |
Can't see thru platic back window anymore | Mike | BMW | 1 | January 16th 05 02:09 AM |