If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Distributor Cap
I know this is not the truck group, but I am trying to find out how to get
to the distributor cap on a 1998 Dodge Ram with a 360 in it. It is so tight you can't even get a plug wire off. Has anyone changed one before? What do you take off to get to it? Jerry |
Ads |
#2
|
|||
|
|||
Distributor Cap
"Jerry Imhoff" > wrote in message ... > I know this is not the truck group, but I am trying to find out how to get > to the distributor cap on a 1998 Dodge Ram with a 360 in it. > It is so tight you can't even get a plug wire off. Has anyone changed one > before? > What do you take off to get to it? > > Jerry > > Jerry the cap is in a tight place, It is held on with 2 Phillips screws that are also a hex bolt. I believe 7mm. Purchase the cap and wires and you will see how it is held on Glenn Beasley Chrysler Tech |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
distributor? | randy pape | Technology | 2 | February 16th 07 06:36 PM |
LF: 71 distributor | jjjoseph | Corvette | 1 | July 13th 06 05:41 AM |
new distributor Q | Dave Lee | Jeep | 7 | March 6th 05 01:49 AM |
Help with distributor | Lkwhite | Technology | 5 | February 28th 05 09:28 PM |
YJ distributor | Dave Lee | Jeep | 3 | February 8th 05 04:16 AM |