|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#1
November 25th 05, 05:42 AM
posted to alt.hi-po.mopars,rec.autos.makers.chrysler
|
|||
|
|||
Magnum EFI to carb conversion
Let's say hypothetically I have a Magnum 318 Dodge truck with a dead
ECM and I want to get rid of the ECM entirely. I know there is a carb manifold available, will a standard electronic or points distributor fit these engines? Or is there an aftermarket one that does and provides conventional triggering and advance mechanisms? If it has an automatic, does its box need the data from the ECM and if it does, can it be rewired to use other inputs or a non-electronic-engine box? 
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Suzuki SJ10 carb conversion | [email protected] | 4x4 | 6 | November 16th 05 08:45 AM |
| 1980 LeBaron Carb | nirodac | Chrysler | 5 | November 5th 05 08:00 AM |
| FS: 2 yr. old. EDELBROCK EPS800 Carb incl.extra jets/rods/springs,etc. | dave | Corvette | 3 | June 27th 05 10:23 PM |
| 2.6 Mitsubishi Carb to Trade | CaravanGuy | Chrysler | 1 | May 7th 05 11:31 AM |
| Dodge Magnum, seen one? | GRL | Dodge | 3 | April 14th 04 04:06 PM |
Threaded Mode