A Cars forum. AutoBanter

If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below.

Go Back   Home » AutoBanter forum » Auto makers » Dodge
Site Map Home Register Authors List Search Today's Posts Mark Forums Read Web Partners

Heater/AC fan speed control 1999 Intrepid ES



 
 
Thread Tools Display Modes
  #1  
Old June 30th 04, 04:52 PM
Dan
external usenet poster
 
Posts: n/a
Default Heater/AC fan speed control 1999 Intrepid ES

Anyone know the exact location of the resistor gizmo which controls
the fan speed on a 1999 Intrepid ES? I know it's "in the ductwork,"
but don't know where. The blower only runs on high, so I'm pretty
certain I need to replace the resistor speed control. I've found a
couple things with wires on them going into the duct below the glove
box, but they are not the resistor speed control I'm looking for. Do
I need to pull the center console to get to it?

Dan
Ads
  #2  
Old July 3rd 04, 02:07 AM
seabringlx2003
external usenet poster
 
Posts: n/a
Default

before you go getting into the wiring harness replace the switch panel with
all the switches that may just be shot , check out ebay for one , its nown
to happen with chrylser from time to time

  #3  
Old July 3rd 04, 02:07 AM
seabringlx2003
external usenet poster
 
Posts: n/a
Default

before you go getting into the wiring harness replace the switch panel with
all the switches that may just be shot , check out ebay for one , its nown
to happen with chrylser from time to time

  #4  
Old July 4th 04, 03:36 PM
Kevin
external usenet poster
 
Posts: n/a
Default

It should be under the glove box. It has a lot of wires going to it and when
you pull it out it doesn't look like the resistor blocks of the old cars
it's a flat thing about 2" x 3" and costs under $5.00 at the dealer.


"Dan" > wrote in message
...
> Anyone know the exact location of the resistor gizmo which controls
> the fan speed on a 1999 Intrepid ES? I know it's "in the ductwork,"
> but don't know where. The blower only runs on high, so I'm pretty
> certain I need to replace the resistor speed control. I've found a
> couple things with wires on them going into the duct below the glove
> box, but they are not the resistor speed control I'm looking for. Do
> I need to pull the center console to get to it?
>
> Dan



  #5  
Old July 4th 04, 03:36 PM
Kevin
external usenet poster
 
Posts: n/a
Default

It should be under the glove box. It has a lot of wires going to it and when
you pull it out it doesn't look like the resistor blocks of the old cars
it's a flat thing about 2" x 3" and costs under $5.00 at the dealer.


"Dan" > wrote in message
...
> Anyone know the exact location of the resistor gizmo which controls
> the fan speed on a 1999 Intrepid ES? I know it's "in the ductwork,"
> but don't know where. The blower only runs on high, so I'm pretty
> certain I need to replace the resistor speed control. I've found a
> couple things with wires on them going into the duct below the glove
> box, but they are not the resistor speed control I'm looking for. Do
> I need to pull the center console to get to it?
>
> Dan



  #6  
Old July 5th 04, 09:58 PM
Dan
external usenet poster
 
Posts: n/a
Default

On Sun, 4 Jul 2004 09:36:54 -0500, "Kevin" >
wrote:

>It should be under the glove box. It has a lot of wires going to it and when
>you pull it out it doesn't look like the resistor blocks of the old cars
>it's a flat thing about 2" x 3" and costs under $5.00 at the dealer.
>
>
>"Dan"
>> Anyone know the exact location of the resistor gizmo which controls
>> the fan speed on a 1999 Intrepid ES? I know it's "in the ductwork,"


>> Dan

>

I have removed the small removeable piece of ductwork under the glove
box, and found two places where wires enter the larger permanent duct.
Neither one is the fan speed control resistor. Do I need to remove
the glove box to see it? The two things I found only have two wires.
I'm looking for something with four wires or five, I think.

Dan
  #7  
Old July 5th 04, 09:58 PM
Dan
external usenet poster
 
Posts: n/a
Default

On Sun, 4 Jul 2004 09:36:54 -0500, "Kevin" >
wrote:

>It should be under the glove box. It has a lot of wires going to it and when
>you pull it out it doesn't look like the resistor blocks of the old cars
>it's a flat thing about 2" x 3" and costs under $5.00 at the dealer.
>
>
>"Dan"
>> Anyone know the exact location of the resistor gizmo which controls
>> the fan speed on a 1999 Intrepid ES? I know it's "in the ductwork,"


>> Dan

>

I have removed the small removeable piece of ductwork under the glove
box, and found two places where wires enter the larger permanent duct.
Neither one is the fan speed control resistor. Do I need to remove
the glove box to see it? The two things I found only have two wires.
I'm looking for something with four wires or five, I think.

Dan
 




Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

vB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Forum Jump

Similar Threads
Thread Thread Starter Forum Replies Last Post
idle speed control motor temptress2972 Dodge 4 July 21st 04 04:23 AM
1995 dodge intrepid cruise control davewillis01 Dodge 4 July 4th 04 05:18 PM
1999 Intrepid starting problem WKJ Dodge 2 June 14th 04 07:42 PM
2004 Dodge Intrepid Cruise Control Bill99 Dodge 12 June 11th 04 02:29 AM


All times are GMT +1. The time now is 02:08 AM.


Powered by vBulletin® Version 3.6.4
Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.
Copyright ©2004-2024 AutoBanter.
The comments are property of their posters.