If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#11
|
|||
|
|||
New carburettor- At least for me.
Hi Chris
I read a few posts on berryman cleaner but I can't find it here in Portugal. I can find a bootles of 4 liters of WD40 put I think that it wouldn't be enough. Joćo |
Ads |
#12
|
|||
|
|||
New carburettor- At least for me.
Hi Joćo
Diesel isn't bad at cleaning engine parts. I haven't tried it on carbs though. Rich > wrote in message oups.com... Hi Chris I read a few posts on berryman cleaner but I can't find it here in Portugal. I can find a bootles of 4 liters of WD40 put I think that it wouldn't be enough. Joćo |
#13
|
|||
|
|||
New carburettor- At least for me.
Hi Rich,
I would like to put it shining :-) and it will be impossible using Diesel. I will call to a guy that worked on VW for 35 years. He will know what to do. He cleaned the air filter for me and I notice a huge difference. I was just trying to avoid calling him. Joćo |
#14
|
|||
|
|||
New carburettor- At least for me.
"I read a few posts on berryman cleaner but I can't find it here in
Portugal. I can find a bootles of 4 liters of WD40 put I think that it wouldn't be enough. " The last time I was at checker auto parts they had a couple different brands of gallon container carburetor soak. I only used berryman because it came recommended by someone else and it has a 'seal' on the top that is designed to keep the solution from evaporating. I'm not sure if the other brands do this. Basically they put some other chemical into the can with the carb cleaner that will form a layer on top of the solution. You could probably get away with any brand so long as you have a large enough container to completely cover the main body and top cover. You could try going the spray carb-cleaner way and try to direct the spray into every single passageway, but I've personally had better results by letting the casting soak for a day or two. Chris |
#15
|
|||
|
|||
New carburettor- At least for me.
|
#16
|
|||
|
|||
New carburettor- At least for me.
yep, methylene chloride in portuguese cloreto de metileno
IT IS NASTY!!! Joćo |
#17
|
|||
|
|||
New carburettor- At least for me.
|
#18
|
|||
|
|||
New carburettor- At least for me.
ultrasonic bath!?!?!?!?! Could you explain it better?
Today, I disassembled the carburetor. Look the inside! http://i1.tinypic.com/ncf2uc.jpg http://i1.tinypic.com/nceh6c.jpg Joćo |
#19
|
|||
|
|||
New carburettor- At least for me.
Hi Bob,
Do you think that's good idea to remove everything from that dirty carb. I'm talking about choke shaft, throttle shat, etc. Joćo |
#20
|
|||
|
|||
New carburettor- At least for me.
|
Thread Tools | |
Display Modes | |
|
|