If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Diz rebuild
Guys,
I need to get rid of some excessive shaft play in this 034 that I picked up for cheap. I did this to one a couple years ago and it works just fine, just added new gaskets and spacers, straight forward job. Well my old brain is failing me but for the life of me I can't get the point plate back in at all, and seemed like it was harder to get out than the other one too. I seem to remeber the one I did before was just a piece of cake, and I didn't even have a vise then. What am I missing? |
Ads |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Top end 258 rebuild | Rod's SHAW | Jeep | 4 | December 3rd 07 02:22 AM |
Rebuild or buy new | YouGoFirst | Jeep | 22 | March 10th 07 02:33 PM |
Can I rebuild it? | CherokeeGirl | Jeep | 5 | August 1st 06 06:42 PM |
rebuild, yay! | Brian Hirt | VW air cooled | 2 | April 16th 06 04:37 AM |
when to rebuild 16v ?? | DFRee | VW water cooled | 2 | February 14th 05 01:25 AM |