|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#1
August 30th 06, 09:20 PM
posted to rec.autos.makers.ford.explorer
|
|||
|
|||
No turn signals work but flashers do!!
I have a '92 Ford Explorer and when I signal a left turn the light
inside does not come on and nor do the exterior signals. When i signal a right turn the interior light stays on rather than blink, but still front nor rear exterior lights work. Although when I turn the 4-way flashers on they work. Any ideas would be great. 
|
| Ads |
|
#2
August 31st 06, 03:24 PM
posted to rec.autos.makers.ford.explorer
|
|||
|
|||
|
No turn signals work but flashers do!!
> wrote in message oups.com... >I have a '92 Ford Explorer and when I signal a left turn the light > inside does not come on and nor do the exterior signals. When i signal > a right turn the interior light stays on rather than blink, but still > front nor rear exterior lights work. Although when I turn the 4-way > flashers on they work. Any ideas would be great. > There are different fuses for the turn signals and the hazard lights. Turn signals use 15 amp, fuse 5 in the interior fuse panel. Hazard lights use fuse 4 there Charlie
|
|
#3
September 5th 06, 06:32 AM
posted to rec.autos.makers.ford.explorer
|
|||
|
|||
|
No turn signals work but flashers do!!
On Thu, 31 Aug 2006 10:24:08 -0400, "Charlie Bress"
> wrote: > > wrote in message roups.com... >>I have a '92 Ford Explorer and when I signal a left turn the light >> inside does not come on and nor do the exterior signals. When i signal >> a right turn the interior light stays on rather than blink, but still >> front nor rear exterior lights work. Although when I turn the 4-way >> flashers on they work. Any ideas would be great. >> > >There are different fuses for the turn signals and the hazard lights. >Turn signals use 15 amp, fuse 5 in the interior fuse panel. >Hazard lights use fuse 4 there > >Charlie > I think they may use different flashers too. He might have a bad flasher or some burned out bulbs.
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| 01 Turn Signals Intermittment | aRKay | Corvette | 1 | July 13th 06 05:08 AM |
| 99 Monte Carlo Turn Signals/Hazards don't work | Monte | Technology | 5 | June 30th 06 05:09 PM |
| Intermittent C5 Turn Signals | aRKay | Corvette | 2 | May 7th 06 09:30 PM |
| 2000Jet Turn Signals GONE | [email protected] | VW water cooled | 1 | February 17th 06 01:36 AM |
| Turn Signals & Flashers don't work - 99 Grand Cherokee | RDS1024 | Jeep | 2 | March 10th 05 02:24 AM |
Linear Mode
