If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Highest gears for Dana 60?
Hi all,
What's the highest ratio available for Dana 60 axles? 3.54 is the highest I've been able to find. I'd like to go to 3.08 if possible. Thanks, Dan |
Ads |
#2
|
|||
|
|||
Looks like 3.54 is the lowest available. Maybe a call to Randy's Ring and
Pinion could give you a led. But you can go to a creeping low 7.17 if you wanted to. A Ford 9" is comparable and gets the high ratio you are looking for. http://www.extremegearoffroad.com/axles.htm ( just one link to information I found ) "Dan Youngquist" > wrote in message . org... > Hi all, > > What's the highest ratio available for Dana 60 axles? 3.54 is the highest > I've been able to find. I'd like to go to 3.08 if possible. > > Thanks, > Dan |
#3
|
|||
|
|||
Looks like 3.54 is the lowest available. Maybe a call to Randy's Ring and
Pinion could give you a led. But you can go to a creeping low 7.17 if you wanted to. A Ford 9" is comparable and gets the high ratio you are looking for. http://www.extremegearoffroad.com/axles.htm ( just one link to information I found ) "Dan Youngquist" > wrote in message . org... > Hi all, > > What's the highest ratio available for Dana 60 axles? 3.54 is the highest > I've been able to find. I'd like to go to 3.08 if possible. > > Thanks, > Dan |
Thread Tools | |
Display Modes | |
|
|